Gronomics MEGB 34-34 User manual

www.gronomics.com East Bethel, MN USA 763-753-7374
Continued
Parts List
ITEM QTY. PART # DESCRIPTION
1 4 3200E Corner Post, 4” x 4” x 32”
2 2
3 10
3102T Side Rail w/Cleat, 31” x 5-1/2” x 1”
3100T, 3100TL Side Rail, (one w/Logo) 31” x 5-1/2” x 1”
4 2 Corner Notched Bottom Board, 31-7/8” x 4-1/2” x 1”
5 4
6 4
7 1
3178NR
3178
4545
FL3652
Bottom Board, 31-7/8” x 5-1/2” x
Post Cap, 4” x 4” x 1-1/2”
Fabric Liner, 22” x 36”
1
Parts Identification
Stack matching pieces in piles. Using the parts list, locate
and count the individual pieces and verify that you have
received the correct number of pieces.
If any pieces are missing or replacement parts are
required, contact Gronomics at 1-855-299-6727.
NOTE: Ground preparation is optional, however we
recommend leveling area under frame of product, or
place product directly on a flat level surface before
filling with soil.
Modular Elevated Garden Bed
34” x 34” Assembly Instruction
Item #: MEGB 34-34
3
2
4
5
6
1
Packaged & Inspected by: Date:
Side Rail Assembly
2
Stand two 4” x 4” x 32” corner posts (Item 1) upright.
Locate a 31” x 5 1/2 “ side rail w/cleat (Item 2). With cleat located at the
bottom and facing you, install side rail w/cleat into the slots and slide down
to the bottom of the slots.
Repeat procedure for the two remaining corner posts and 31” x 5-1/2 “ side
rail w/cleat.
2
Cleat
1 1
Parts List Product Care & Maintenance
Western Red Cedar will turn a weathered
grey if left unfinished. Although no finish
is required for cedar products when used
outdoors,a natural oil finish applied
regularly will help maintain the beauty
and minimize cracking and drying. It is
recommended to use Gronomics
Garden Bed Oil
(Item # GBO-1Q), a non-toxic, food safe
finish that is very easy to apply. Apply Oil
when air and wind temperatures are
between 50-90degrees. Avoid applying in
direct sunlight.

www.gronomics.com East Bethel, MN USA 763-753-7374
5
Bottom Board and Fabric Installation
Place one 31” x 4-1/2” corner notched bottom board (Item 4) on
each end of the garden bed.
Place four 31” x 5-1/2” bottom boards (Item 5) into the garden bed. (Gap
boards evenly to allow for water drainage).
Place fabric liner into the garden bed.
Soil Depth: approximately 12-1/2”
Soil Capacity: 8.6 Cubic Feet
3
Side Rail Assembly (Continued)
Install two 31” x 5-1/2” side rails (Item 3) into the slots and slide down to
the bottom of the slots.
4
5
6
Post Cap Assembly
Remove the rubber cap from the corner posts studs.
Align the hole of the 4” x 4” post cap (Item 6) with stud and tighten until
the cap makes contact with the post.
NOTE: Do not overtighten.
Repeat procedure on all posts.
Rubber Cap
Stud
6
4
Final Side Rail Assembly
Install eight remaining 31” x 5-1/2” side rails (Item 3) one w/Logo into the
slots on each side of the garden bed and slide down.
NOTE: Make sure the boards tongue and grooves fully seat together.
3
Logo
3
3
3