SUNVILLA 11 Foot Offset Umbrella User manual

Screw the Finia Cap (A) into the top of the Sunshade (B) .
Step 2:
Page 2 of 6
With the unbrella base (E) completely filled with water and with the final
umbrella location decided, insert the Sunshade Pole (B) into the Rotation Part
Step 3:
A
B
B
(D) carefuly, it is possile two persons may be needed for this step.

   
Two M8* 16 Bolts (G) and Two Small Washer (F), tighten
Step 4:
Page 3 of 6
Step 5:
Insert the crank (C) handle into Pole Housing hole as shown below.
JF
G
C
Secure Sunshade Pole (B) into Rotation part (D) By using
using # 6 Allen Wrench (J).
Make sure it snaps into housing.

Step 6:
Page 4 of 6
Step 7:
Always open canpoy completely by connecting the internal Upper Pole to Lower Hub as shown.
To raise canpoy, press the button on the umbrella hand slider and lift upwards.
Release the button to set canpoy into desided location. Use the crank (C) handle to
Upper Pole
Lower Hub
open the and close canpoy. To lower canopy first, close canopy by turing
on hand slider to low position.
crank conter colorwise , then push button

Page 5 of 6
Step 8:
Put your hand into handle housing. Adjsut to lower position. Take out
the crank and then put into the hole shown in the below picture (Part 1), rotate left and right
(largest can rotate 35 degree).
All position are shown below.
PART 1
Limit Position
Limit Position

Page 6 of 6
the crank, meanwhile pull down the slider until canpoy is near the stand pole. Then use the stripe to
Step 9:
Pull down the handle housing into the position which is easy to handle the crank, arrow to rotate the
fasten the umbrella.
   
Place the umbrella cover on the umbrella when not in use.
Step 10: