Superior Fireplaces DRI3030TEN-CONTF-BLK User manual

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE 1
CONTEMPORARY FACE KITS
INSTALLATION INSTRUCTIONS FOR INSTALLING CONTEMPORARY FACE KITS
FOR USE WITH DRI3030TEN, DRI2530TEN AND DRI3030TENC GAS FIREPLACE INSERTS
900145-01
REV. NC, 12/2013
HEARTH PRODUCTS
KITS AND ACCESSORIES
KIT CONTENTS (See Figure 1)
1 ea. Face
1 ea. Instruction Sheet
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
INSTALLATION INSTRUCTIONS
Installation of the surround assembly is required prior to installing the
Contemporary Face Kit. Install the surround assembly per instructions in
the installation and operation manual provided with the fireplace insert.
Step 1.Using the 5/32” allen wrench, remove the two screws on the side
of the upper air deflector and loosen the two screws on the top.
See Figure 2.
Figure 1
Contemporary Face Kits
Cat. No. Model Description
F1845 DRI3030TEN-CONTF-BLK Contemporary Face - Black
F1846 DRI3030TEN-CONTF-MNK Contemporary Face - Mink
TOOLS NEEDED
5/32” Allen Wrench
GENERAL INFORMATION
All of these parts may scratch and bend, great care should be used
in handling them.
If you encounter any problems, need clarification of these instructions
or are not qualified to properly install this kit, contact you local distribu-
tor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
Figure 2
Upper Air Deflector Loosen Top Screws
(2 places)
Remove Side Screws
(2 places)
12/06/13(3)

2
Printed in U.S.A. © 2013 IHP LLC
P/N 900145-01 REV. NC 12/2013 1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
Figure 5 - Face Installation
Figure 6 - Completed Installation
Figure 4
Figure 3
The face has two hooks on each side that slide over and hang on the
surround brackets at position (1) shown here. The face may slide slightly
from side to side to center the face on the glass.
uLocation where hooked brackets on face will hang
u
Step 3.Install the face onto the surround brackets as shown in Figures
2 and 3. Each side of the face has a bracket with two (2) hooks.
Place the face on the surround hanging brackets as shown in
Figures 2, 3 and 4 by placing the hooks on position (1).
Step 2. Adjust air deflector height down and reinstall the side screws in the
other set of mounting holes. Tighten the top screws. See Figure 3.
Upper Air Deflector
Reinstall Side
Screws (2 places)
Tighten Top Screws
(2 places)
IHP reserves the right to make changes at any time, without notice, in design, materials,
specifications, and prices, and also to discontinue colors, styles, and products. Consult your
local distributor for fireplace code information.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE