IHP 36LBFOD-BS User manual

CU
S
Report No. 14-020 1
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
TOOLS REQUIRED
• MediumPhillipsScrewdriver
• 3/8"Open-endwrench
• 1/4"Drivesocket
GENERAL INFORMATION
Thedoorassemblyconsistsofarightandleftglasspanelassemblywith
thedoorhandlesfactorymounted.Includedisafourpiecedoorframe
witheight(8)screwsandahood(hoodpackagedseparately),whichare
requiredforassembly.Fireplaceslistedbelowonthisdocument,have
beendesignedtoacceptthesedoorswithminimumeffort.
Thesebi-foldglassdoorassemblieshavebeendesignedforusewith
andmaybeeasilyttedtoyourOutdoorGasFireplace,ModelsPolaris™
36/42,VRE4336/42,E36ODGandE42ODG.
Donotalterormodifythesedoorassembliesorareplacemalfunction
orarehazardmayresult.
ThesedoorshavebeentestedandlistedbyPFSCorperation.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
Read this instruction sheet in its entirety before beginning.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
SHUT DOWN THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
HEARTHPRODUCTS
KITSANDACCESSORIES
INSTALLATION INSTRUCTIONS FOR OUTDOOR BI-FOLD GLASS DOORS
MODELS: 36LBFOD-BS (CAT. NO. H4645) AND 42LBFOD-BS (CAT. NO. H4646)
BI-FOLD GLASS DOORS
P/N 750210M
Rev. C 04/2014
Figure 1
Screen Rod
Screws
Screen And
Rod Assembly
INSTALLATION PROCEDURE
Remove Screens And Rods:
Usinga5/16"socketornutdriver,removethescreenrodassemblies(see
Figure 1).RemovethescreenrodscrewsasshowninFigure 1.Pullout
therodsfromlocatingholesonthesideofthereboxopening.
IMPORTANT! REINSTALL SCREEN ROD SCREWS INTO THE EXISTING
HOLES WHERE REMOVED.
ThescreenandrodassembliesmustnotbeinstalledwhentheBi-Fold
GlassDoorKitisinstalled.Youmaywishtoretainthescreenandrod
assembliesiscasetheBi-FoldGlassDoorKitiseverremovedinthefuture.
IMPORTANT! IF THIS OPTIONAL BI-FOLD GLASS DOOR KIT IS EVER
REMOVED, THE ROD AND SCREENS MUST BE REINSTALLED FOR SAFE
OPERATION OF THE APPLIANCE.
fire-parts.com

2
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Place The Hood
Lip Up And
Under The Face
Top Opening
Hood Lip
Attaching Screw
(Seen From Below)
Step-1
Step-2
Face Top
Spring Clip
Screws (8)
Assembled
Door Frame
Pivot
Point
Lower
Frame
Pivot Pin Roller Pin
Lock
Figure 2
Figure 5
Figure 4
Figure 3
Hood Installation:
Begintheassemblybyinstallingthehood(packagedseparately).Be
certaintoremoveanyprotectiveplasticcoatingsforthestainlesssteel
partsbeforeinstallingthosecomponents.
Step 1. Turnoffthereplaceandallowittocoolbeforeproceeding.
Step 2. Placethehoodlipunderthefacetopopening,asshowninFigure
2 - Step 1.Attachthehoodwithtwo(2)screws,oneeachside,
asshowninFigure 2 - Step 2.
Frame Assembly:
Assemblethefourpiecedoorframewiththeeight(8)screwsprovided
asshowninFigure 3.Twospringclipsattachinsidetheuppertrack
asillustrated.
Door Installation:
Step 1. Startingwiththelowerendofeithertherightorlefthanddoor
holdthedoorataslightangletothedoorframeouteredgewith
thetoptiltedtowardthecenter.
 Swingthelowercornerofthedoorovertheholeinthelower
frameandengagethelowerpivotpinintotheholeonthelower
frameofthereboxopening(Figures 5 and 6).
Afterassembly,theframeinsertsunderthehoodasshowninFigure 4
anddropsdowninsidetheopeningwithoutfasteners.
fire-parts.com

3
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Pivot Pin Roller Pin
Upper Door
Guide Track
Spring Clip
Fully Open or
Fully Closed
Front-Open Systems
ADJUSTMENT FOR DOOR ALIGNMENT
Thedoorsareproperlyadjustedwhenthetopdoortrimisinastraight,
levellineandthegapbetweenthedoorsisevenatthetopandbottom.
Ifadjustmentsarerequired,graspthedoorhandleandloosenthelower
doorpivotpinusinga3/8"openendwrench*.Slidethedoorpanelon
thehingepinuntilthegapbetweentheupperdoortrimandupperframe
iseven.Retightenthelowerdoorpivotpin*.Repeatthisprocedurefor
theoppositedoorifneeded.
*NOTE: Upper door pivot pins can also be loosened for adjustment
purposes; however, it is easier to loosen lower pins.
GENERAL OPERATING PRECAUTIONS AND INSTRUCTIONS
CAUTION: THESE GLASS DOORS ARE LISTED ONLY FOR USE WITH THE
FIREPLACE OR APPLIANCE MODELS SHOWN ON THE FRONT PAGE.
USE ON ANY OTHER FIREPLACE OR APPLIANCE MAY CONSTITUTE A
POTENTIAL FIRE HAZARD.
•Usereplacetoolscarefullytoavoidstrikingtheglass.
•Keepwiremeshscreensclosedduringreplaceuse.
Lower
Pivot Pin
Figure 6
Figure 8
Figure 7
Step 2. Tiltthetopofthedoorintoplaceandcarefullyensurethatthe
upperpivotpinandrollerpinisintheupperdoorguidetrack.
Step 3.Continuetotiltthetopofthedoorintoplaceuntiltheupperpivot
pinengagesthespringclipandthepivotpinlocksintoplace
withintheholeofthespringclip(see Figure 7).
Step 4.Repeatthisprocedurefortheoppositedoorassembly.
IMPORTANT: THE FINISH OF THESE DOORS MAY BE PROTECTED WITH
A SELF ADHERING PLASTIC COATING THAT MUST BE REMOVED BEFORE
HEAT IS GENERATED BY A FIRE IN THE FIREBOX. TO PREVENT MELT-
ING, ENSURE THAT ANY PLASTIC COATING PROTECTING THE FINISH
OF THESE DOORS IS REMOVED FOLLOWING INSTALLATION. REFER TO
THE FIREPLACE INSTALLATION AND CARE AND OPERATION INSTRUC-
TIONS FOR DETAILED INSTRUCTIONS REGARDING THE MAINTENANCE
OF THE FINISH OF THESE DOORS.
CAUTION: THE FRONT-OPEN FIREPLACE OR APPLIANCE SHOULD
ONLY BE OPERATED WITH THE GLASS DOORS FULLY OPEN OR FULLY
CLOSED (SEE FIGURE 8).
CAUTION: GLASS AND METAL FRAMES GET HOT — ALWAYS USE
HANDLES TO OPEN AND CLOSE THE DOORS.
CLEANING
NEVER CLEAN THE GLASS WHEN THE DOORS ARE HOT. DO NOT USE
AMMONIA OR ANY AMMONIA BASED GLASS OR HOUSEHOLD CLEANER
TO CLEAN THE GLASS OR THE DOOR FRAME. AN AMMONIA BASED
CLEANER WILL DAMAGE THE FINISH.
Removedirtandgrimefromthedoorsusingacleandampenedtowel
followedbywipingwithadrytowel.Toremovestubbornstainsfromthe
doors,useamildsoapsolutionandtoweltogentlyscrubawaystain.
Takecarenottoscratchtheglasssurface.Donotuseabrasivecleaners.
IMPORTANT: THESE GLASS DOORS UTILIZE TEMPERED GLASS WHICH
IS DESIGNED FOR USE WITH HIGH TEMPERATURES BUT CAN UNEX-
PECTEDLY SHATTER. DO NOT SIT CLOSE TO THE GLASS.
Temperedglasswillbreakintosmallparticlesifitshouldshatterunex-
pectedly.Iftheglassbreaks,particlesofextremelyhotglasscouldbe
dischargedintothesurroundingenvironment,therebycreatingariskof
personalinjuryorre.Observationoftheaboveoperatingprecautions
andinstructionswillreducetheriskofpersonalinjuryorre.
Ifthetemperedglasspanebecomesscratchedorchipped,itcreatesa
weaknessintheglasswhichcancausetheglasstobreakwhenheated.
Replacethepaneofglassbycontactingyournearestdistributorordealer.
fire-parts.com

4
PrintedinU.S.A.©2002IHP
P/N 750210M REV. C 04/2014
IHPreservestherighttomakechangesatanytime,withoutnotice, indesign,materials,
specications,pricesandalsotodiscontinuecolors,stylesandproducts.Consultyourlocal
distributorforreplacecodeinformation.
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
fire-parts.com