
USER MANUAL
1. Remove existing collection bags from hopper of the collection unit.
(Not shown)
2. Drape the leaf bag opening over the collection unit with the logo
facing up.
3. Pull the flap down over the front of the hopper and wrap the sides of
the bag around the collection unit.
4. Tighten cinch cords equally on both sides, assuring that the front flap
of the leaf bag is tucked inside. Wrap up excess cord to prevent from
catching or tangling.
NOTE: Allow leaf bag to completely dry before storing.
DO NOT reverse the tractor with the bag
installed.
DO NOT operate if bag is not tightly
secured to the hopper.
DO NOT allow any children on or near
the unit.
DO NOT overfill the TerraKing Leag Bag.
For dry leaf collection only, not for use
with grass collection.
Before installing the bag, mow around
all unusual areas blowing material out
where it can be easily picked up.
CAUTION: Do not allow dry leaves to
collect on the engine or muffler area of
the vehicle.
WARNING
Push in on center loop of the cinching
device and pull the end of the rope
until taught.
Pull back on the center of the cinching
device.
To Tighten Cord: To Release Cord:
Limited Warranty
•12 months from date of Purchase
• ItemscoveredinLimitedWarranty–defectsincraftsmanship;sewing,seams,thedrawstring,
and the cinching device.
•Warranty does not cover tears due to the bag catching on roots, sticks, stones or other items
within the yard.
•Any tears in leaf bag should be patched immediately (patch included)
•Iron On Patch Instructions:
o Set the iron to a med/hot setting.
o Be very careful with polyester fabrics, since applying the high heat necessary for ironing
on patches can burn the fabric or cause it to get discolored.
o Place the patch in the desired location and cover with a thin piece of cloth.
o Iron and apply firm pressure evenly on the patch for approx 30-40sec.
o Iron the opposite side for approx 20-30sec to reinforce.
TerraKing by Superior Tech Inc.
43 Industrial Rd, Ephrata, PA 17522
www.TerraKing.com
(717)286-1444