Supermicro X10DAi User manual

SUPERMICR R
ContaCt InformatIon
MNL-1563-QRG-10a
• Website: www.supermicro.com
• General Information: [email protected]
• Tech Support: [email protected]
• Phone: [phone], Fax: [phone]
© 2016 Supermicro Computer Inc. All rights reserved. Reproduction of this document whether in part or in whole is strictly prohibited without Supermicro's written consent. All Trademarks are property of their respective entities. All information provided is deemed accurate at the time of printing; however, it is not guaranteed.
PaCkage Contents
X10DaI/X10DaC/X10DaX
QuICk referenCe guIDe rev 1.0a
• One (1) Supermicro Motherboard
• One (1) I/O Shield (MCP-260-00045-1N)
• One (1) Quick Reference Guide (MNL-1563-QRG)
for your system to work ProPerly, Please DownloaD aPPro-
PrIate DrIvers/Images/user'smanual from the lInks below:
• Manuals: http://www.supermicro.com/support/manuals/
• Drivers & Utilities: ftp://ftp.supermicro.com/
• Safety:
http://www.supermicro.com/about/policies/safety_information.cfm
• Six (6) SATA Cables (CBL-0044L) (For X10DAi/X10DAX)
• Two (2) SATA Cables (CBL-0044L) (For X10DAC)
• Two (2) SAS Cables (CBL-SAST-0532) (For X10DAC)
LED Indicators
Jumper Description Default Setting
JBT1 Clear CMOS See Chapter 2
JII2C1/JII2C2 SMBus to PCI-E Slots Pins 2-3 (Normal)
JPL1 GLAN1 & GLAN2 Enable/Disable Pins 1-2 (Enabled)
JPL2 GLAN2 Enable/Disable Pins 1-2 (Enabled)
JPME2 Manufacture Mode Select Pins 1-2 (ME Mode)
JPS1 (X10DAC Only) SAS Enable Pins 1-2 (Enabled)
JWD1 Watch Dog Pins 1-2 (Reset)
Connector Description
Audio_FP (JA1) Audio Connector for Front Access
JAudio1 7.1 HD (8-channel High-Denition) Audio Connector
BT1 Onboard CMOS Battery (See Chapter 3 for Used Battery Disposal)
CPU1 Slot1/Slot3 PCI-E 3.0 x16 Slots (Note: CPU1 has to be installed.)
CPU2 Slot5 PCI-E 3.0 x16 Slot (This slot is available when CPU2 is installed.)
CPU2 Slot2 PCI-E 3.0 x8 Slot (This slot is available when CPU2 is installed.)
CPU2 Slot4 PCI-E 3.0 x8 Slot (The slots are available when CPU2 is installed.)
PCH Slot6 PCI-E 2.0 x4 in x8 Slot
FAN1-7, FANA CPU/System Fan Headers
J24 ATX 24-Pin Power Connector (See Warning on Page 1-6.)
JD1 Speaker/Power LED Indicator
JF1 Front Panel Control Header
JL1 Chassis Intrusion
JPII2C1 Power Supply SMBbus I2C Header
JPWR1/JPWR2 12V 8-Pin Power Connectors (See Warning on Page 1-6.)
JSD1/JSD2 SATA DOM (Device_On_Module) Power Connectors
JSPDIF_In SPDIF_(Sony/Philips Digital Interface)_In Header
JSPDIF_Out SPDIF_(Sony/Philips Digital Interface)_Out Header
JTBT1 GPIO Header for Thunderbolt Add-on Card
JTPM1 TPM (Trusted Platform Module)/Port 80 Header
LAN1/LAN2 G-bit Ethernet Ports 1/2
I-SATA0-9 Serial_Link ATA Connections 0-9 supported by Intel PCH
SAS0-3, 4-7 (JS2) Serial_Link SCSI Connections 0-3, 4-7 supported by LSI SAS Controller
SP1 Onboard Buzzer (Internal Speaker)
STBY1 Standby Power Header
T-SGPIO 1/2/3 Serial-Link General_Purpose IO Headers 1/2/3
USB 5/6 (3.0) Rear USB 3.0 Ports 5/6
USB 7/8 (3.0) Rear USB 3.0 Ports 7/8
USB 9/10 (3.0) Front-accessible USB 3.0 Connections 9/10
USB 0/1 Rear USB 2.0 Connections 0/1
USB 2/3 Front-accessible USB 2.0 Connections 2/3
USB 4 Type A USB 2.0 Connector USB 4
LED Description State Status
DS2 (X10DAC Only) SAS Heartbeat LED Green: Blinking SAS: Normal
LE2 Standby PWR LED Green: On SB Power On
Note 1: Graphics shown in this quick reference guide are for illustration only. Your components may or may not look exactly the same as the drawings shown in this
guide.
Note 2: For optimized airow, please follow your chassis airow direction to install the correct CPU heatsink direction.
Populating DDR4 RDIMM/LRDIMM Memory Modules
Jumpers
Motherboard Layout and Features
Connectors
Jumpers and Connectors
Memory Support
CPU Installation
Note: Refer to Chapter 1 of the user manual for detailed information on jumpers, connectors,
and LED indicators.
Note: Refer to Chapter 2 of the user manual for detailed information on memory support and CPU/motherboard
installation instructions.
= mounting hole
Heatsink Installation Front Panel Control (JF1)
CPU Support
Release Tabs
Notches
CPU Keys
Socket Keys
CPU Pin1
Dual Intel®E5-2600v3/v4 Series Processors (Socket R3-LGA 2011); each processor
supports dual full-width Intel QuickPath Interconnect (QPI) links (of up to 9.6 GT/s one
direction per QPI).
This motherboard supports up to 2048 GB of Registered (RDIMM)/Load Reduced
(LRDIMM) ECC DDR4 2133/1866/1600 MHz memory modules in 16 DIMM slots.
Note: Memory speed support is pending on the CPUs installed on the moth-
erboard. For the latest memory updates, please refer to the Tested Memory
List posted on our website (http://www.supermicro.com/products/motherboard).
Populating DDR4 RDIMM/LRDIMM Memory Modules
Speed (MT/s)
Voltage (V)
Installing DIMM Memory Modules
1. Rear USB 3.0 Port 5
2. Rear USB 3.0 Port 6
3. Rear USB 2.0 Port 0
4. Rear USB 2.0 Port 1
5. SPDIF_Out
6. Surround_Out
7. CEN/LFE_Out
8. Mic_In
9. Line-Out
10.Line_In
11. Gigabit LAN 1
12.Gigabit LAN 2
13.Rear USB 3.0 Port 7
14.Rear USB 3.0 Port 8
1
2
3
4
6
7
8
9
10
11
12
5
13
14
Insert and tighten the
screws in the sequence
as shown below.
Screw#2
Motherboard
Screw#1
Screw#3
Back Panel I/O Connectors
Power Button
OH/Fan Fail LED
1
NIC1 LED
Reset Button
2
HDD LED
Power LED
Reset
PWR
Vcc
Vcc
Vcc
Vcc
Ground
Ground
1920
Vcc
X
Ground NMI
X
Vcc
PWR Fail LED
NIC2 LED
JAUDIO1
JPL1
JPL2
BT1
CLOSE 1st
OPEN 1st
X10DAi/DAC/DAX
Rev. 1.01
PCH
LAN CTRL
LAN CTRL
Audio CTRL
SAS
CTRL
FAN7
FP CTRL
LE2
JS7
UARTO
CLOSE 1st
OPEN 1st
SAS CODE
J24
JF1
JSTBY1
FAN2
FAN6
FAN1
FANA
FAN4
FAN3
FAN5
DS1
SP1
J23
JWD1
JI2C1
J30
JPME2
JI2C2
J29
JBR1
J19
JPS1
T-SGPIO3
T-SGPIO1
T-SGPIO2
JTPM1
JSD2
JSD1
JL1
JSPDIF_IN1
JSPDIF_OUT1 JD1
JPP1 JPP0
JS5
JPWR2
JPWR1
JPI2C1
JTBT1
JS2
JS6
BIOS
LICENSE
MAC CODE
BAR CODE
USB0/1
AUDIO_FP
I-SATA5
MDIO
SAS4~7
USB9/10(3.0)
USB7/8(3.0)
TPM/PORT80
I-SATA8 I-SATA6USB4
USB2/3
I-SATA7
I-SATA9
SAS0~3
CPU1 SLOT1 PCI-E 3.0 X16
I-SATA4
CPU2SLOT2 PCI-E 3.0 X8
I-SATA3
I-SATA2
I-SATA1
JBT1
CPU1 SLOT3 PCI-E 3.0 X16
I-SATA0
CPU2 SLOT4 PCI-E 3.0 X8
CPU2 SLOT5 PCI-E 3.0 X16
PCH SLOT6 PCI-E 2.0 X4 (IN X8)
P1 DIMMC2
P2 DIMME1
P1 DIMMC1
P2 DIMMF1
P1 DIMMD1
P1 DIMMD2
P2 DIMME2
P2 DIMMF2
P1 DIMMB2
P2 DIMMH2
P2 DIMMH1
P1 DIMMB1
P2 DIMMG2
P1 DIMMA1 P1 DIMMA2
CPU1
P2 DIMMG1
LAN1/2
USB5/6(3.0)
CPU2
Battery
Battery
Populating RDIMM/LRDIMM DDR4
Memory Modules for the E5-2600v3-
based Motherboard
Populating RDIMM/LRDIMM DDR4
Memory Modules for the E5-2600v4-
based Motherboard
Type
Ranks Per
DIMM
and
Data
Width
DIMM Capacity
(GB)
Speed (MT/s); Voltage
(V);
Slot Per Channel (SPC)
and DIMM Per Channel
(DPC)
1 Slot Per
Channel 2 Slots Per Channel
1DPC
1DPC
2DPC
4Gb
8Gb
1.2V
1.2V
1.2V
RDIMM SRx4 8GB 16GB 2133 2133 1866
RDIMM SRx8 4GB 8GB 2133 2133 1866
RDIMM DRx8 8GB 16GB 2133 2133 1866
RDIMM DRx4 16GB 32GB 2133 2133 1866
LRDIMM
QRx4 32GB 64GB 2133 2133 2133
LRDIMM
3DS
†
8Rx4 64GB 128GB 2133 2133 2133
Type
Ranks Per
DIMM
and
Data
Width
DIMM Capacity
(GB)
Speed (MT/s); Voltage (V);
Slot Per Channel (SPC) and DIMM Per
Channel (DPC)
1 Slot Per
Channel 2 Slots Per Channel
1DPC 1DPC 2DPC
4Gb 8Gb 1.2V 1.2V 1.2V
RDIMM SRx4 8GB 16GB 2400 2400 2133
RDIMM SRx8 4GB 8GB 2400 2400 2133
RDIMM DRx8 8GB 16GB 2400 2400 2133
RDIMM DRx4 16GB 32GB 2400 2400 2133
LRDIMM QRx4 32GB 64GB 2400 2400 2400
LRDIMM
3DS 8Rx4 64GB 128GB 2400 2400 2400