Supermicro X6DHP-8G Installation and operating instructions

®
LAN1
S
UPER X6DHP-8G
DIMM 1B (Bank 1)
FP Control
Fans
1/2
PCI-X100 MHz #2 ZCR (Slim Slot)
USB
0/1
CPU 1
GLAN
CTLR
LAN2
IPMI
DIMM 1A (Bank 1)
DIMM 2B (Bank 2)
DIMM 2A (Bank 2)
DIMM 3B (Bank 3)
DIMM 3A (Bank 3)
JWOR1
Mouse
Battery
SPKR
VGA
(South
Bridge)
ICH5R
ATI
PHX
UID
SCSICh.B
PCI-X100 MHz #1
JPA3
SCSI
Ctrl
JPA2
SCSI Ch A
COM1
COM2
Floppy
IDE2
IDE1 SATA1
USB 2/3
SATA0
JWF1
JP17
JWF2
JP18
ATX PWR1 8-Pin
PWR2
CPU2
Lindenhurst
(North
Bridge)
E7520
BIOS
DA1
DA2
XJ4F1
XJ4F2
PLL
SEL
Fans
3/4
Fans
5/6
Fans
7/8
Fans
9/10
PCI-Ex8 #2
PCI-Ex8 #1
KB
JL1
JD1
JPG1
J22
JPA1
JPL1
J24
JBT1
JRST1
JWD1
Addendum to the X6DHP-8G motherboard
Attention!!
ImportantNotice!!
(Read the information listed below before using this product.)
PLLSEL Select (Memory Speed Select):
Jumpers XJ4F1/XJ4F2 (PLLSEL Select): These jumpers allow the user to select PLLSEL (Memory Speed). Make
sure that the jumper settings are set correctly according to your memory speed before you power on the system.
(*Warning!! If these jumpers are not set correctly according to your memory speed, video display failure may
occur!!!)
DDR
*333 MHz
266MHz
XJ4F1 XJ4F2
Closed Closed
Open Open
PLLSEL Select
Jumper Settings
(XJ4F1/XJ4F2)
(*Default:Closed-333MHz
)
XJ4F1/XJ4F2
(PLLSEL: Memroy
Speed Select)
(*Note: the default setting is “Closed” for both jumpers to
enable DDR Memory at 333MHz. However, if your memory
speed is 266MHz, please make sure to set both jumpers
to “Open”.)
Add-X6DHP-8G Rev. 1.0a-06/10/05