Suptek MD8SP User manual

Parts
G2:M4x12(x8)
30mm
G1:M4x30 (x8)
H1:(x8) H2:(x8)
16mm
M5
F:Φ4x12(x8)
M4
VESA plate x2
S4/S5 wrench
Clamp x1
Main mount x1
A: Install the main mount on a desk B: Install the monitor on the main mount
A1.1
B1
B3
B4 B5
B2
H1 or H2
F G1 or G2
unscrew the pre-positioned screw
tighten the screw
A2.1
A2.2
A2.3
A1.3
WARNING:
Make sure the
screws are
tightened.
WARNING:
Make sure the
screws are
tightened.
WARNING:
Make sure the
screws are
tightened.
WARNING:
Hold the monitor
in case of falling.
WARNING:
Make sure the
screws are
tightened.
A1.2
WARNING!
Incorrect installation may cause loss of life, personal injury and
damage of property. Please read the following information before
installation.
If you do not understand the manual or meet any problem, please
contact your local qualified installation person.
If any of the parts are damaged or lost, do not install it. If you need
to exchange parts, please contact retailer.
This item holds 17” - 27” LCD monitors less than 13.2lbs weight.
This item is simple and easy to install on a desk or disassemble.
To ensure security, the capacity of the desk need to be over 3 times
of the weight of all loading (include mount, monitor and its
accessories).
Do not use this item for any purpose or in any configuration not
explicitly specified in this instruction.
For safety, be careful with the slideable parts of the item.
Be careful with the wires when installation of the monitor.
We are not responsible for: reformed or incorrect installation,
beyond the capacity, damage during usage.
Hold monitors: 17”-27”
Weight capacity: 2.2-13.2 lbs (1-6kg)
Compatible VESA patterns: 75x75mm/100x100mm
MD8SP
INSTALLATION MANUAL
A1: Clamp installation
A2: Grommet installation
405mm
160mm
70mm
±180°
±180°
±90° ±80°
360°
350mm
0-67mm
24-98mm
400mm

pinch and push in
tie the wires
Adjustment of torque force
after installation
Adjust torque force
WARNING
WARNING
Decrease Increase
360° rotation is not suggested if gravity of
monitor is not in the center of it.
360° rotation
C2
D1
D2
open the ties
tighten the screw
C1
pinch and pull out
unscrew the
pre-positioned
screw
C3
S4 wrench
S4 wrench
C: Cable management
E: Adjustment of joints
D: Adjustment of torque force
+: Increase torque force
- : Decrease torque force
WARNING:
Do not loosen the
screw completely.
1. The monitor could stop at any height after hung on the
mount. No adjustment needed.
2. The monitor bounces itself after hung on the mount. Press
down the monitor with one hand and make sure the arm is
horizontal. Use S5 wrench and turn the screw in “-”
direction with the other hand (little by little) until the monitor
can stop at any height.
3. The monitor falls itself after hung on the mount. Raise the
monitor with one hand and make sure the arm is horizontal.
Use S5 wrench and turn the screw in “+” direction with the
other hand (little by little) until the monitor can stop at any
height.
±180° swivel
±80°
1. Make sure the monitor is hung on the mount before adjustment.
2. Make sure the weight of monitor is within the capacity.
[email protected]
S5 wrench