SURGE SG60043-44 Use and care manual

SG60043-44 Firmware Update Instructions
Required Equipment
•Computer
•USB - USB-C data transfer cable (cable included with device is compatible)
•SwitchPad Pro Controller
•Firmware Update File
Update Instructions
Step 1
Unzip & extract the provided folder
Step 2
Plug the USB-C data cable into your wireless controller. Press and hold the L3 Button
(click left stick in) and connect the USB cable to the computers USB port, release L3 after
connecting to computer.

SG60043-44 Firmware Update Instructions
Step 3
Run the update firmware software by double clicking the file “SG60043-44-FirmwareUpdate-
07-13-2021
Step 4
Follow the prompts, click “OK” to complete the upgrade
Step 5
After the update is complete, reset the controller via the button on the back and follow the
synchronization guide to connect your controller (manual included)
NOTE: If you experience any problems please e-mail [email protected]