ENG
6
PC Wired Gamepad
• To check and congure in «XInput» mode, select «Prop-
erties» in the «Game devices» window, the «Properties:
Controller (XBOX 36 ...» window will pop-up (Fig.8). In
the «Verication» tab, you can check the execution of
commands when you press the buttons and rotate the
joystick. To calibrate the joystick, select the «Settings»
tab, click «Calibrate» and follow the instructions.
• To check and congure in DirectInput mode, select
Properties in the Game Devices window, and the Prop-
erties: USB Vibration Joystick (BM) window pops up. In
the «Test» tab, you can check the execution of com-
mands when you press the buttons and rotate the joy-
sticks, and also check whether the joystick is connected
to the PC in the «Connected State» line (Fig. 9).
In the «Calibration» tab, you can center the position of
both joysticks (Fig. 10). To do this, you need to set them
to the middle position, then click «Default» and «Set».
After calibration, you must click «Accept» or «OK» on the
bottom line of this window to save the changes.
• In the «Vibration Test» tab, you can check the oper-
ation of both vibrators together by pressing the «Both
force» button; or separately, by pressing the «Left force»
and «Right force» buttons. And also by rotating the left
joystick in the analog mode of operation or by pressing
the 8-way joystick in the digital mode of operation (Fig.
11). To stop the test, press the «Stop» button. Moving
the cursor in the row «Vibration strengthv» we can in-
crease or decrease the force of vibration. To save the
settings, click «Apply» or «OK» in the bottom line of this
window.
• The «About» tab provides information about the ver-
sion of the installed driver.
• The device can work in analog and digital modes. The
modes are switch by pressing the HOME button. In this
case, in the analog mode, the second indicator lights up,
and in the digital mode, the third one lights up.
• With PS3.
Connect the gamepad to an available USB port. The sys-
tem will automatically establish a connection, and the
LED corresponding to the number of the gamepad in
the system will light up.
• With Android.
To connect to devices running Android, you need a USB OTG cable (not included). After con-
necting the gamepad with this cable, the system will automatically establish a connection,
while the rightmost indicator lights up.
Fig. 8
Fig. 9
