General Information
1013447-101_rev-07
SC 303/313
SCAN COIN
1 General Information
SCAN COIN AB reserves the right to revise and improve its
products as it sees fit. This publication describes the product at the
time of publication and may not reflect the product at all times in
the future.
This publication, or parts thereof, may not be reproduced in any
form, by any method, for any purpose other than the purchaser’s
personal use, without the express permission of SCAN COIN AB,
Sweden.
1.1 Declaration of Conformity
We, SCAN COIN AB, Malmö, Sweden, declare under our sole
responsibility, that the product in this manual, to which this
declaration relates, is in conformity with the following standards or
other normative documents:
• EN 60 950-1:2006+A11:209 + A1:2010;
• EN 61000-6-1 (2007)
• EN 61000-6-3 (2007)
following the provisions of Directive:
• Low Voltage Directive 2006/95/EC
• EMC Directive 2004/108/EC.
1.2 Environmental Compliance
Note! If the equipment contains batteries or accumulators, dispose of these
separately according to local requirements.
WEEE Directive (valid in the EU only)
Waste Electrical and Electronic Equipment Directive 2002/96/EC.
Equipment marked with this symbol must be treated separately and
in accordance with the local legislation that requires proper treatment
of, recovery and recycling of used electric and electronic equipment.
Contact your SCAN COIN representative for further details.
1.3 Responsibility
The supplier of the equipment accepts no responsibility for injury or
damage to personnel or equipment, if the equipment is altered in any
way or used in a manner for which it was not intended at the time of
delivery.
If the conditions for use of the equipment are changed, the supplier
must be contacted or the declaration of conformity is invalidated.
