2
2 3
Continuous Clean™
www.SwifferContinuousClean.com
Continuous Clean™
www.SwifferContinuousClean.com
Filter Removal and Replacement
1. Unplug device
2. Grab top handle and twist gently counter-
clockwise to remove cover. Set aside.
3. Remove filter and discard in proper waste
receptacle.
4. Check air inlet (below fan) and if necessary wipe
with dry cloth or vacuum to remove soil.
5. Attach the filter to the fan by sliding the open
filter end with the internal elastic band over the
fan base. The filter should form a seal around the
fan housing. The top of the filter will remain loose
until inflated.
6. Gently insert the Filter Identity Chip into the slot
on the fan housing, ensuring that the Swiffer logo
is facing outward.
7. Plug the power cord into the power cord inlet
on the bottom of the fan housing. Once inlet is
secure, plug the power cord into a power outlet
(refer to Important Safety Instructions).
Note: Fan will initially operate at a higher speed
(~30 seconds) to aid filter inflation.
8. Lower cover over the inflated filter and twist
clockwise to lock in place. Cover must be in
place for unit to work properly. If filter does not
fully inflate inside cover, tug gently until the filter
height is just below top of cover.
