swiftech MCB-120 User manual

1703, E. 28th St, Signal Hill, CA 90755 USA – Tel. [phone] – F 562-595-8769 – www.swiftnets.com
1 of 2
™
Parts list
Parts QTY PARTS QTY
MCB-120™ Housing assembly 1 Coolsleeves™ 20” (*)
Retention hardware (screws, etc..) 1 PCI Pass-Thru kit 1 (*)
½” tubing 2’ (*) Worm drive clamps 4 (*)
(*) only included with complete kit
1/ PCI pass-thru kit installation
o Insert the PCI bracket into an available opening, and secure it to the chassis.
o Insert your fan electrical connector through the slotted hole of the PCI bracket now. Only 3-pin
connectors (the type that connect to the motherboard) are small enough to pass through the
slotted hole. 4-pin Molex connectors (the type that connect to your power supply) will require that
the terminals be removed from the Molex housing first.
o From inside of the chassis, insert the pass-thru adapters through each hole of the PCI bracket.
The threaded portion of the adapters should be exposed outside of the case.
o Screw the nuts to the adapters. The nuts are designed to slightly overlap the edges of the PCI
chassis opening, to provide a more secure installation.
2/ Housing / fan & radiator installation: please refer to diagram page 2.

2 of 2 Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28th St, signal Hill, CA 90755, USA – T [phone] – F [phone] – All content
Copyright Swiftech 2004 – Last edited 7-31-04 – Subject to revision without notice
MCB-120
holding plate
MCB-120
housing
120x25mm
fan
Radiator
Chassis
#6 x 1 1/4" sheet
metal screw
(coarse thread)
6-32 nylon
nut
#4 x 1/4"
sheet metal screw
(course thread)
6-32 x 1" machine screw (fine thread) Use alternate 6-32 x 1 1/2" for thick acrylic panels or provided 4-40 x 1 1/4" with nuts and washers for 60mm fan openings
1/2" Nylon spacer (use as needed to provide clearance with side panel) or alternatively use (1) or (2) provided nylon washers
#4 worm-drive
hose clamp
Pass-thru adapter
Custom PCI
bracket
Pass-thru nut Pump Inlet
1/2" ID tubing
Fan power connector thru PCI bracket
IMPORTANT DISCLOSURES
While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech assumes no liability expressed or implied for any
damage(s) occurring to your components as a result of using Swiftech cooling products, either due to mistake or omission on our part in the above
instructions, or due to failure or defect in the Swiftech cooling products.
WARRANTY
Our products are guaranteed for 12 months from the date of delivery to the final user against defects in materials or workmanship. During this period,
they will be repaired or have parts replaced provided that: (I) the product is returned to the agent from which it was purchased; (II) the product has
been purchased by the end user and not used for hire purposes; (III) the product has not been misused (*), handled carelessly, or other than in
accordance with any instructions provided with respect to its use. This guarantee does not confer rights other than those expressly set out above and
does not cover any claims for consequential loss or damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as
a consumer.