Swing-N-Slide NE 4569L User manual

NE 4569L
wing•N• lide • 1212 Barberry Drive • Janesville, Wisconsin 53545
Visit our web site at: www.swing-n-slide.com or call us at
1-800-888-1232
ASSEMBL INSTRUCTIONS
To register your product visit:
http://www.swing-n-slide.com
Other benefits include information on product warranties, assembly plan updates, joining our
mailing list for new products and promotions, receiving our newsletter, and providing feedback on
products.
No. of Children: Up to 2
Min. Use Zone:
18 '-6'' Dia.
Set Dim.
6'-6'' Dia.
Est. Building Time: 2 hrs.
6'-6'' Diameter
Set Dim.
18'-6'' Diameter
Min. Use Zone
!WARNING:
Assembly by an adult.

Installat on Safety – Have You:
Consulted the assembly instructions supplied with your particular model?
Noted this accessory is to be used only on Swing•N•Slide approved designs? (Do not alter its design or add/remove components.)
Made sure all hardware is tightened securely? (Supplied bolt covers must also be fastened securely.)
Using a hacksaw, cut off all protruding threaded ends of bolts and other fasteners and remove any sharp edges with
a metal file as needed, and coated fastener ends with lead free paint?
Placed the equipment on level ground, not less than six feet (1.8 meters) from any structure or obstruction such as a fence, garage,
house, overhanging branches, laundry lines, or electrical wires?
Made sure item is not installed over concrete, asphalt, packed earth or any other hard surface? (A fall onto a hard surface can result
in serious injury to the equipment user.)
Followed all anchoring and shock absorbing surfacing requirements as they apply?
Made sure not to allow children to use equipment until it is properly installed?
Operat ng Safety – Have You:
Determined that on-site adult supervision is provided for children of all ages?
Warned children the following before allowing them to use the equipment?
Not to walk close to, in front of, behind or between moving items.
Not to push empty seats or other accessories.
Be sure to sit in the center of the seat with full weight on the seat.
Not to attach items to the playground equipment that are not specifically designed for use with the equipment such as but not
limited to, jump ropes, clotheslines, pet leashes, cables and chain. They may cause a strangulation hazard.
Not to use equipment in a manner other than intended.
Not to get off equipment while it is in motion.
Not to use the equipment when it is wet.
Determined that only one child per planned occupant seat should be allowed on this set at one time.
Determined children must be dressed appropriately for play. Avoid hooded jackets, bicycle helmets, clothing with draw strings and
loose fitting clothes which could become entangled or snagged on equipment.
Safety Ma ntenance – At the beginning of every season and twice monthly thereafter:
Rake and check depth of loose fill protective surfacing material to prevent compaction and maintain appropriate depth. Replace as
necessary.
Check all nuts, and bolts during the usage season for tightness and tighten as required. (It is
particularly important that this procedure be followed at the beginning of each season.)
Oil all metallic moving parts monthly during usage period.
Check all hardware and equipment for sharp edges during usage season. (Replace when necessary. It is especially
important to do this at the beginning of each new season.)
Check seats and metal parts monthly during usage season for evidence of deterioration.
Sand rusted metal parts and repaint using non-lead based paint.
D sposal Instruct ons
When the equipment is taken out of service, it must be disassembled and disposed of in such a way that no unreasonable hazards
will exist at the time the set is discarded.
Important! Add t onal Safety Instruct ons for all Sw ng-N-Sl de Playground Equ pment.
Save th s nstruct on sheet n the event the manufacturer needs to be contacted.
Observ ng the follow ng statements and warn ngs reduces the l kel hood of ser ous or fatal njury
Safety Checkl st for Sw ng-N-Sl de Play Sets and Accessor es
2

This product is intended for single family home/residential use only and not intended for use in any public setting.
Placement in any public setting constitutes a misuse of this product.
IMPORTANT!
ADDITIONAL REQUIRED SAFETY INSTALLATION INSTRUCTIONS
According to ASTM requirements, all kits must be anchored to the ground and, if the unit has a climbing rope, the rope end must be anchored to the ground. If soil conditions
permit stakes to be pulled out easily, cementing into ground is necessary.
•To anchor the un t to the ground, Follow the instructions included in this plan for applying Anchor-It devices to your unit, or use 2" x 4" x 18" (4 mm x 9 mm x 4 7mm) pressure-
treated stakes. Pound stakes into ground at least 12" (30 mm) at all inside corners of the posts (including A-frame legs and climbing unit posts). Attach with four (4) 16D (3-1/2")
galvanized nails per stake into each tower and/or A-frame upright.
• If the un t has a cl mb ng rope, anchor the rope end.
• Once the un t s completely assembled and before ch ldren are allowed to play on t, proper shock-absorb ng surfac ng mater al must be nstalled. This may be accomplished by
using loose-fill materials at a sufficient depth. The Consumer Product Safety Commission “Handbook for Public Playground Safety” lists the following materials and required
depths that are sufficient for home/residential application. For fall height protection up to 9 ft. (2.742m) [recommended for Swing•N•Slide kits]:
LOOSE FILL MATERIAL REQUIRED (UNCOMPRESSED) DEPTH
1
in. (mm)
Wood Mulch 9" (229mm)
Double Shredded Bark Mulch 9" (229mm)
Uniform Wood Chips 12" (30 mm)
Fine Sand 12" (30 mm)
Fine Gravel 12" (30 mm)
These depths were der ved from the CPSC Handbook. Sw ng•N•Sl de has not done ndependent tests to determ ne these requ red depths.
When properly installed, shock absorbing material will completely cover the horizontal baseboards on climbing units. This protective surfacing must extend a m n mum of 6 ft.
(1.828m) in all directions from the perimeter of the equipment or from the outermost edges of any component. For example, a slide extending beyond the platform must have
protective surfacing at least 6 ft. (1.828mm) out from both sides as well as the end. For swings, the protective surface must extend at least 14 ft. (6m) out from both the back and
front of the swing when the swing is in its rest position.
Swing-N-Slide® MANUFACTURERS LIMITED WARRANTY
Swing-N-Slid ® tak s gr at prid in th quality and durability of our products. Our Manufactur r’s Limit d Warranty provid s confid nc and d monstrat s our commitm nt
to providing quality r sid ntial playground products.
MANUFACTURER’S LIFETIME LIMITED WARRANTY
Swing-N-Slid ® warrants its th rmoform d slid s and climbing mountains to b fr from d f cts in workmanship and mat rials, und r normal us and conditions, for th
lif tim of th product.
MANUFACTURER’S 5 YEAR LIMITED WARRANTY
Swing-N-Slide® warrants its Custom R ady-to-Build Play S t kits and acc ssori s to b fr from d f cts in workmanship and mat rials, und r normal us and conditions,
for a p riod of 5 y ars.
MANUFACTURER’S 5 YEAR LIMITED WARRANTY
Swing-N-Slide® warrants its No-Cut and Wood Compl t R ady-to-Ass mbl Play S t kits against wood rot and t rmit damag , and to b fr from d f cts in
workmanship and mat rials, und r normal us and conditions, for a p riod of 5 y ars for structural wood compon nts.
C smetic defects that do not aff ct th structural int grity of th product, or natural d f cts of wood such as warping, splitting, ch cking, twisting, shrinkag , sw lling or
any oth r physical prop rti s of wood that do not pr s nt a saf ty hazard, ar not cov r d by this warranty.
MANUFACTURER’S ONE YEAR WARRANTY
Swing-N-Slide® warrants its canopy roofs and/or tarps, and Timb r GLOVE lumb r wrap to b fr from d f cts in workmanship and mat rials, und r normal us and
conditions, for a p riod of on y ar.
Swing-N-Slide® will r pair, or at its discr tion, r plac any part within th stat d warranty p riod which is d f ctiv in workmanship or mat rials. This d cision is subj ct
to v rification of th d f ct upon d liv ry of th d f ctiv part to Swing-N-Slid ® at 1212 Barb rry Driv , Jan svill , Wisconsin, 53545. Any part(s) r turn d to Swing-N-
Slid ® must hav prior approv d R turn Authorization Numb r and proof of purchas , including th dat of purchas . This warranty is valid only if th product is us d for
th purpos for which it was d sign d and install d at a r sid ntial, singl family dw lling. This warranty is void if th product is put to comm rcial or institutional us . This
warranty do s not cov r (a) products which hav b n damag d by acts of Natur , n glig nc , misus , or accid nt, or which hav b n modifi d or r pair d by
unauthoriz d p rsons; (b) th cost of labor; or th cost of shipping th product, any part, or any r plac m nt product or part.
Swing-N-Slide® DISCLAIMS ALL OTHER REPRESENTATIONS AND WARRANTIES OF ANY KIND, EXPRESS, IMPLIED, STATUTORY OR OTHERWISE, INCLUDING THE
IMPLIED WARANTIES OF MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE. Swing-N-Slid ® WILL NOT BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES. This warranty is non-transf rabl and do s not xt nd to th own rs of th product subs qu nt to th original purchas r. Som stat s do not
allow limitations on impli d warranti s or xclusion of incid ntal or cons qu ntial damag s, so th s r strictions may not b applicabl to you. This warranty giv s you
sp cific l gal rights. You may also hav oth r rights, which vary from stat to stat .
This warranty als d es n t apply t :
• Structur s not r ct d, maintain d or insp ct d in conformanc with Swing-N-Slide® installation plans
• Structur s that hav had parts add d or substitut d not in conformanc with Swing-N-Slide® installation plans
•Parts that hav b n modifi d, alt r d or misus d
•Parts that hav not b n us d as d sign d or int nd d
•Damag du to acts of Natur , vandalism, abnormal us or abus as d t rmin d by Swing-N-Slide®
For further information on playground safety, the Consumer Product afety Commission
(CP C) publishes the Outdoor Home Playground afety Handbook which can be downloaded for free
from www.cpsc.gov. An additional resource is the American ociety of Testing and Materials (A TM)
tandard Consumer afety Performance pecification for Home Playground Equipment (A TM F1148)
which can be purchased and downloaded from www.astm.org.
3

4
Assembly Instructions
TOOLS AND HARDWARE

5
D
C
C
I
G
K
I
I
x1
x3
x6
D
C
a
x4
x2
x3
x3
x8
x8
x8
x3
K
G
I
a
f
g
e
i
x1
x1
x4
A
B
m
a
I
A
m
e
f
g
a
i
B
m
Assembly Instructions
Fig. 1
Fig. 2
Fig. 3

x2
x4
x4
E
i
c
x2
x2
i
c
x2
Fx1
x1
i
b
c
i
c
i
E
B
B
A
F
F
A
i
b
x2
n
n
n
6
Assembly Instructions
Fig. 4
Fig. 5
Fig. 6 Fig. 7
Note: nug Bolt Only, DO NOT Overtighten.

H
H
7
Assembly Instructions
12''
12''
14''
78''
27-1/2''
11-3/4''
26-1/4''
Opti nal Seesaw Anch ring Meth d:
1. Plac th S saw in th d sir d position. Mark a 12'' x 12'' squar around ach of th S saw f t and, using th s guid lin s,
dig hol s 14'' d p.
2. Fill ach hol with a minimum of 12'' of concr t . Do not xc d th ground l v l.
3. Plac S saw back in d sir d position so that nds of l gs ar c nt r d ov r c m nt fill.
4. Fit th anchor into th c nt r of th concr t so that th ir tops ris out of th concr t and loop ov r nds of l gs.
N te: R mov anchors b for concr t s ts, cr ating a mounting hol in th c m nt.
5. Onc concr t is dry, slid anchors into mounting hol s. Fill in r maining ar a of hol s with surfacing and compact until firm.
N te: Do not us th S saw until th concr t is compl t ly dry and hol s ar fill d.
Weight Limit: 85 lbs Per Child
x3
H
Fig. 8

© PlayCore Inc. 2011 Printed In U A LA 6186
Questions???...
Call our Customer Service Department
at 1-800-888-1232