Symbol LS9203 Manual

Setup Instructions for
Autogas REGAL Touch
LS9203

LS9203 Setup Instructions
2
Introduction
This document provides instructions for programming the Symbol LS9203 scanner for use with an Autogas REGAL Touch.
Required Hardware
•Cable
• CBA-R01-S07PA (RS232 Cable, DB9 Female, TxD on 2, 7 ft. Straight), or
• CBA-R02-C09PA (RS232 Cable, DB9 Female, TxD on 2, 9 ft. Coiled).
• Power Supply
• 50-14000-008 (110VAC for N. America), or
• 50-14000-009 (220VAC for Europe and Asia), or
• 50-14000-010 (100VAC for Japan).
Scanner Setup
The following parameters need to be set:
•SetDefaults
• Standard RS-232
• Baud Rate 9600*
• Parity Space
• Hardware Handshaking: None*
• Software Handshaking: None*
• 2 Stop Bits
•7-Bit
• Scan Data Transmission Format: Append suffix value "1013".
* Already set by default.

3
Scan the following bar codes to configure the LS9203 scanner:
Set All Defaults
Standard RS-232
Parity Space
1
2
3

LS9203 Setup Instructions
4
2 Stop Bits
7-Bit
Scan Options
4
5
6

5
<Data><Suffix>
Enter
Scan Suffix (Value 1)
7
8
9

LS9203 Setup Instructions
6
1
0
1
10
11
12

7
3
Enter
13
14

LS9203 Setup Instructions
8
73-60833-SI05
Revision A - September 2004
Symbol Technologies, Inc.
One Symbol Plaza
Holtsville, N.Y. 11742-1300
http://www.symbol.com
73-78423-SI03
Revision A - December 2005
Symbol Technologies, Inc.
One Symbol Plaza
Holtsville, N.Y. 11742-1300
http://www.symbol.com