Tactical technologies TPS18-2Si User manual

actical Technologies Pty Ltd
[phone] Tel www.tac-tech.com.au [phone] Fax
Designed & Manufactured
In Australia
TPS18-2Si
N645
Installation Manual
18V DC 2A Power Supply

General
This power supply is designed for indoor use only.
The TPS18-2Si superceeds the TPS18-2DC from the previous Tactical model range.
TPS18-2Si provides a regulated 18.2Vdc at up to 2Amps continuous for Intercom & Access Control
applications.
Note that this model does not provide battery charging facilities.
Incorporating short circuit shutdown, current limiting and thermal overload protection, TPS18 Si models
have been designed and thoroughly tested to comply with stringent new Australian & New Zealand
Electrical Safety and EMC standards.
The advanced design of the TPS18-2Si provides outstanding performance in the eld, whilst maintaining
signicantly lower operating temperatures than most currently available linear supplies.
Connection
DC output terminals are specied in the layout overleaf and can provide a maximum of 2A.
Please take start-up / inrush current into account when conguring your system.
The power supply will current limit and shut down if a total of 2 Amps load is exceeded.
Equipment must be installed & serviced
by suitably qualied service personnel
in a restricted access area. There are no
user serviceable parts inside.
N645
Document: TPS18-2Si.pdf
Dangerous Voltage Inside !
No user serviceable parts inside
Do not remove module covers
CAUTION

Document: TPS18-2Si.pdf
A B C D
TPS18-2Si
E
AOutput Terminals - connect to load (Observe Polarity)
BAC OK LED
COutput OK LED
DModel Compliance & Date of Manufacture Label
EThese terminals are NOT used in this model
F240V Mains Power Cable
F
LAYOUT

Warranty Statement
Tactical Technologies Pty Limited guarantees this product against defective parts and workmanship
for a period of twelve (12) months from the date of purchase. If any defect appears during the warranty
period, please return the goods to Tactical Technologies Pty Limited freight paid. The goods will be
repaired or replaced, then returned.
Tactical Technologies Pty Limited assumes no liability for consequential or indirect damage and
accepts no responsibility for repairing damage to products caused by misuse, careless handling or
where repairs have been made by others. In the interest of ongoing product development, Tactical
Technologies Pty Limited reserves the right to modify, vary or alter the design of this product without
written notice.
Tactical Technologies Pty Ltd ABN 13 066 744 661
Tel: [phone] www.tac-tech.com.au 5 Buttereld St, Blacktown NSW 2148 Fax: [phone]
“ Changing The Way You Think About Power ! ”
TPS18-2Si
Output Voltage to Load Factory set to 18.2 V dc
Output Current to Load 2A Max
Weight 2.6 kg
Dimensions 192L x 132W x 90H mm
Input Voltage 240V ac / 50 - 60Hz
Input Current 350mA (0.35A)
Safety Standards AS/NZS 60950: 2003
EMC Standards AS/NZS CISPR 14.1:2003 C-Tick N645
Mounting 4 x 3mm mounting holes
Specications