Taga TSF-002 User manual
TSF-002
FLOORSTANDING SPEAKER FEET AND SPIKES
Instruction Manual
Edition 09-2020
2
2
Safety Instructions
1.Read Instructions - All the safety and operating instructions should be read before the
product is operated.
2.Retain Instructions - The safety and operating instructions should be retained for fu-
ture reference.
3.Heed Warnings - All warnings on the product and in the operating instructions should
be adhered to.
4.Follow Instructions - All operating and use instructions should be followed.
5.Cleaning - do not use liquid cleaners or aerosol cleaners.
6.Water and Moisture - Do not use this product near water - for example, near a bath
tub, wash bowl, kitchen sink or laundry tub; in a wet basement; or near a swimming
pool; and the like.
7.Accessories - Do not place the speaker after installing the feet or spikes on an unsta-
ble cart, stand, tripod, bracket or table. The product may fall, causing serious injury
to a child or adult and serious damage to the product. Any mounting of the product
should follow manufacturer’s instructions and should use a mounting accessory rec-
ommended by the manufacturer.
8.Heat - The product should be situated away from heat sources such as radiators, heat
registers, stoves or other products that produce heat.
9.Operating Environment - Operating environment temperature and humidity of the unit:
+5°C to +35°C (+41°F to +95°F); less than 85% RH.
An exclamation mark in a triangle is intended to alert the user
to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
EN_safety_TSF_09-20
The weight of the speaker which is installed
on 4 feet with spikes or only 4 spikes should
not exceed 45 kg (99.21 lbs).
For installation use only hardware and accessories provided
with this product.
This product is designed for the speakers which are compatible
and recommended by the manufacturer.
Compatible speakers are listed on www.TagaHarmony.com
3
Introduction
TheTSF-002 feet and spikes may be supplied with your speaker or separately.
For new speakers - before unpacking!
To prevent damage to the speaker choose one of the below
installation options:
A1 - install the feet and spikes, while the speaker is still in the
carton. Place the carton with the speaker on the oor in the
upside down position and open it from the bottom and remove the
protective bag from the bottom of the speaker or;
A2 - take out the speaker from the carton without removing it from
a protective bag. Place the speaker securely on a stable surface in
a horizontal position above the oor level. Remove the protective
bag from the bottom of the speaker.
Two installation options for your choice:
I. To install feet and spikes or;
II.To install the spikes only
TAGA Harmony recommends the rst option.
Note! The actual speaker shape and the placement of feet and spikes may vary from
the ones shown in the gures.
Required tool (not supplied with this product)- cross screwdriver.
Bolt M8 (x8)
D
Top pad (x4)
B
Content (set for 1 piece of speaker):
4
Installation
I. FEET and SPIKES
Attach the spikes and the top pads to all 4 feet as shown in the gure.
To avoid air leak from the cabinet, screw 4 bolts (D) into the remaining
4 empty threaded sockets on the bottom of the speaker.
Attach the feet while the speaker is still in the carton (A1) or after the speaker is
removed from the carton (A2). Using 2 bolts (D) screw in each foot securely into the
threaded sockets located at the bottom side of the speaker as shown in the gure (pla-
ce the speaker in A3 or A4 position).
II.SPIKES only
Install the spikes (C) while the speaker is still in the carton (A1) or after the speaker is
removed from the carton (A2). Screw in the spikes into the threaded sockets located
at the bottom side of the speaker as shown in the gure (place the speaker in A5 or A6
position). The outer sockets are recommended for better speaker stability.
www.TagaHarmony.com
TAGA EUROPE
POLPAK POLAND Sp. z o.o.
AL.JEROZOLIMSKIE 331A
05-816 REGUŁY k/WARSZAWY, POLAND
Email: Sales@TagaHarmony.com
IMPORTANT!
Your product is marked with the symbol as showed on the left.
For EU (European Union) member users:
According to the WEEE (Waste electrical and electronic equipment)
Directive, do not dispose of this product as household waste or commercial waste.
Waste electrical and electronic equipement should be appropriately collected and
recycled as required by practices established for your country.
For information on recycling of this product, please contact your local authorities, your
household waste disposal service or the shop where you purchased the product.
Your product is marked with the symbol as showed on the left.
For EU (European Union) member users:
This product has been tested and found in compliance with
requirements of the European Community
2014/30/EU (EMC) directive.
FINAL STEP
Speaker in carton.
Carefully turn the carton with the speaker over to the regular position and place it securly on the oor.
Remove the carton and the internal packaging - your speaker is ready for placement in your room.
Speaker removed from carton.
Carefully turn the speaker over to the regular position and place it securely on the oor.
Remove the protective bag - your speaker is ready for placement in your room.
Spikes height adjustment
In case of an uneven oor and when the speaker is not stable on it, you can slightly adjust the height
of individual spikes turning them clockwise (lower height) or counterclockwise (higher).
Make sure not to fully unscrew the top pad.
Installation
Notes
Notes
Notes
Table of contents
