Tanco E100 SA User manual

1. Remove the transport pin from the load arm.
2. Remove the locking pin from the swivel axle
and rotate the wheel into the working
position. Reinsert the locking pin.
3. Adjust the position of the dispenser to
ensure that the film will be applied to the
centre of the bale.
4. Add the film roll into the dispenser, ensuring
that it is threaded correctly, and attach the
film to the Cut & Start.
TRACTOR CONNECTION
1. Hydraulics
Red pipe > Supply (25-30lpm)
Blue pipe > Return (Free flow return!!)
2. Electrics
1. Connect 12V supply to 3pin plug
2. Connect wrapper harness to controller
3. Control levers
Mount the control levers in the tractor cab. Place it in
a position that is in comfortable reach to the
operator.
ENTERING THE WORKING POSITION
The quick reference guide is not a substitute for the Operators Manual!
Please refer to Operators Manual for more detailed information
2
1
4
1
3
2
E100 SA QUICK REFERENCE GUIDE

CONTROL LEVERS OPERATION
CONTROLLER OPERATION
Current No. of Wraps Target No. of Wraps
Channel Indicator
Program Key Select Channel
-Reset Store Total
- Set
RUN-ON Time –
(Reduce time to stop)
RUN-ON Time +
(Increase time to stop)
162
Unloading / Cut &Start
Wrapping
(Table rotation)
Loading

OPERATION
Loading
1. Lower the load arm to the ground using
lever No. 1.
2. Once the bale is inside the load arm, the
bale can be loaded onto the table by
operating lever No.1 in the opposite
direction.
3. Once the bale is loaded, the load arm can be
lowered using lever No. 1.
Unloading
Wrapping
4. To begin rotating the table, slowly move
lever No. 2.
5. Once the table has completed approx. ½
revolution, the table speed can be
increased by further moving lever No. 2.
6. Once 1 revolution is complete, lever No. 2
will be held in place by a magnet. This
allows for Automatic wrapping.
7. When the target no. of wraps is reached
lever No. 2 will return to neutral position
and the table will stop rotating.
8. When the bale is wrapped, the table might
need to be reversed into the tipping position.
Do this by moving lever No. 2.
9. To begin offloading the bale, operate lever
No. 3. The film will also be cut during
offloading.
10. Lower the table by moving lever No. 3 in the
opposite direction.
11. To prepare for loading the next bale, rotate
the table by moving lever No. 2.

ENTERING THE TRANSPORT POSITION
1. Remove the locking pin from the swivel
axle and rotate the wheel into the
transport position. Reinsert the locking
pin.
2. Rotate the table into the loading position.
3. Raise the load arm fully.
4. Insert the transport pin into the load arm.
This will prevent the load arm from
lowering when driving on the road.
The transport pin should also be used
when the machine is being parked.
Model
Bale Diameter
4 layres
6 layres
8 layres
E100 SA 120 cm
16 wraps
24 wraps
32 wraps
E100 SA 150 cm
20 wraps
30 wraps
40 wraps
SETTING NO. OF WRAPS
This is a guideline only! Misshapen bales may require more wraps to achieve full coverage.
FILM CUTTING ADJUSTMENT
The point during tipping where the
cutter closes can be adjusted by moving
the bolt to a different hole on the
linkage.
The film should be fully gathered on the
cut and start frame when the cutter
closes.