TANEL Electronics WM-3 User manual

Limitations
This warranty becomes null and void if you fail to pack your WM-3
in a manner consistent with the original product packaging and dam-
age occurs during product shipment. This warranty does not cover:
circumstance beyond our company’s control; service required as the
result of unauthorized modifications or service; misuse, abuse;
failure to follow our company operating or maintenance instructions.
Repair or replacement without charge is our company’s only
obligation under this warranty. Our company will not be responsible
for any special, consequential or incidental damages resulting from
the purchase, use, or improper functioning of this equipment
regardless of the cause. Such damages for which our company’s will
not be responsible include, but are not limited to, loss of revenue or
profit, downtime costs, loss of use of the equipment, cost of any
substitute equipment, facilities of services, or claims of your
customers for such damages.
TANEL Electronics & IT
General Partnership
PL , 44-100 Gliwice, Kopernika 121
tel./fax [phone]
email: inf[email protected]
http://www.tanel.com.pl/
GUARANTEE
The manufacturer guarantees the correct functioning of
the Moisture Meter for Waste Paper WM-3 under
normal use for a period of 12 months.
Serial number ......................
Production date ...................
MOISTURE METER
FOR WASTE PAPER
WM-3
USERS MANUAL
1. Application
Moisture Meter for Waste Paper is designed to rapidly
determine the level of moisture contents of waste paper.
2. Operation principle
Moisture meter measures the resistance of the material
(waste paper). It has been calibrated for normal
composition of waste paper.
3. Technical data
Range 6% - 30%
Power 9V, 1 battery 6F22
Electrode length 85 mm
Size 80 * 180 * 250 mm

4. Measurements
Conduct the measurements of moisture contents of
waste paper following these steps:
•take the device out of its case and remove the
protective cap,
•connect the device with the electrode using the
wire provided,
•turn the power on,
•slide the electrode into the waste paper (if it’s
compressed) or firmly press the electrode
against a single piece of waste paper,
•read the result,
•repeat the measurement with at least 3
randomly selected samples,
•the final result is an average of all the
measurements,
•turn the power off.
WARNING:
The measuring range of the device is 6% - 30%.
Moisture contents below 6% is indicated as „LO”.
Results over 30% should be considered as rough
estimates.
5. Changing the battery and storage
The device is equipped with a power level control
circuit. When the power drops below acceptable level a
sign ”LO BAT” appears on the left side of the LCD.
This indicates that the battery has expired and should
be replaced with a new one. To replace the battery
unscrew the screw on the back of the instrument and
carefully remove the back panel. Store the device in a
dry place.
6. Guarantee and Service
The Moisture Meter for Waste Paper WM-3 has a 12
months guarantee.
•all repairs during the guarantee period will be
done within 10 days from the date of delivery,
•all other repairs will be done within 14 days
from the date of delivery.
TANEL Electronic warrants the Moisture Meter for
Waste Paper WM-3 to be free from malfunction and
defects in both materials and workmanship for one year
(12 months) from the date of purchase.
If the Moisture Meter WM-3 does not function properly
during the warranty period due to defects in either
materials or workmanship, our company will, at its
option, either repair or replace the instrument without
charge, subject to the conditions and limitations stated
herein. Such repair service will include any necessary
adjustments and replacement part.
Important
To prevent faulty results in measurements the Producer
recommends that in due time you check your meter
readings with a dry oven test.