Targetti Titano User manual

Titano Installation Guide
Product code: TIT-
Targetti USA - A Targetti Group Company - 750-A W. 17th. St. Costa Mesa, CA 92627 - (714)
513-1991 Email: [email protected] - www.targetti.us - 08.2017 - Page 4 of 4
Targetti USA - A Targetti Group Company - 750-A W. 17th. St. Costa Mesa, CA 92627 - (714)
513-1991 Email: [email protected] - www.targetti.us - 08.2017 - Page 4 of 4
Targetti USA - A Targetti Group Company - 750-A W. 17th. St. Costa Mesa, CA 92627 - (714)
513-1991 Email: [email protected] - www.targetti.us - 02.2020 - Page 1 of 4
6.90”
1.57”
7.16”
7.17”
8.54”
8.73”
:$51,1*
To ensure a maximum efficient use of
the product, read the instructions before
proceeding installment.
This fixture must be installed by a licensed and
qualified electrician. The installer must comply with
NEC and local building codes when installing the
fixture
Electrical current can cause painful shock, serious
injury, or even death. Make sure you turn off the
power supply, ground fixture(s), and make sure all
electrical connections are correct and secured
For use in IP67 installations.
Keep the label of the original packaging if any
eventual future claims are needed
Table of Contents
Installation Instructions
Fixture Preparation
Maintenance
Support Page
Pg.2
Pg.3
Pg.4
Pg.4

Installation Instructions
Targetti USA - A Targetti Group Company - 750-A W. 17th. St. Costa Mesa, CA 92627 - (714)
513-1991 Email: [email protected] - www.targetti.us - 02.2020 - Page 2 of 4
A. Installers will dig out trenches to prep the sleeve
i. Put gravel in the trenches for the J-Box. Requirement by UL for
adequate drainage.
ii. Safety net covers below the J-Box and the conduit pipe to warn diggers
what is below.
B. Position of the J-Box must be an accessible depth between 8.5-11.5" required
for maintenance.
C. Once the sleeve is installed, wire the fixture's power cable through the
J-Box and connect the power cord to the J-Box wiring. Make sure the power
is not live before connecting power cord to line voltage through the J-
Box. Once power cord is connected, connect the power cord with the fixture.
Be sure to secure the connection with water tight connectors to ensure no
water leakage inside the connector.
Incoming conduit
system for line
voltage power
Sleeve for fixture
A
B
C
Gravel for drainage
Fixture's power
cable. Connect
with line voltage
power.
Outgoing conduit
system for line
voltage power
Incoming conduit
system. Connect to J-
Box with 3/4" NPT
connector.
Out-going conduit
system. Connect to J-
Box with 3/4" NPT
connector.
Brass direct
burial J-Box

M5x40
Fixture Preparation
Targetti USA - A Targetti Group Company - 750-A W. 17th. St. Costa Mesa, CA 92627 - (714)
513-1991 Email: [email protected] - www.targetti.us - 08.2017 - Page 4 of 4
Targetti USA - A Targetti Group Company - 750-A W. 17th. St. Costa Mesa, CA 92627 - (714)
513-1991 Email: [email protected] - www.targetti.us - 02.2020 - Page 3 of 4
1
2
1. Once sleeve is set and
fixture is connected, adjust
your viewing optic for
lighting preference based
on fixture's emission type.
2. After, secure the fixture
onto the sleeve with 2 M5
screws
a. Apply only 2.95ft-lbs
(4Nm) of torque to
efficiently secure the
fixture. Make sure to
provide a tight and
even holding for the
fixture and sleeve to
ensure the fixture is
secured.
Pluri-EmissionMono-Emission Bi-Emission

Targetti USA - A Targetti Group Company - 750-A W. 17th. St. Costa Mesa, CA 92627 - (714)
513-1991 Email: [email protected] - www.targetti.us - 02.2020 - Page 4 of 4
Maintenance
•This fixture was designed and manufactured for a durable, long
lasting use with minimum care. To ensure the maximum lifespan of
this product, we encourage our customer to provide a quality visual
inspection of dirt, abnormalities, or signs of moisture inside or
around the fixture every six months.
•If there are any visible sign of issues during the inspection, please
open the fixture, wipe off any moisture inside the fixture and clean
any of the dirt fixture with a soft cloth with cleaning solution around
the trim ring and the ring of the fixture.
o3/($6(',6&211(&77+(),;785(%()25(
&/($1,1*
o'2127635$<$1<&/($1,1*62/87,21',5(&7/<
217+(237,&6
•Once finished with fixture maintenance, be sure to install the trim
ring according to the trim installation directions (pg. 3).
Support
Any questions, problems, or comments you have please
feel free to contact our Customer Service department
during our business hours Monday-Friday 8am-5pm via:
Email: [e-mail]
Phone: [phone]
Visit our website: http://www.targetti.us