Tarter SENTINEL LKF12 User manual

LKF12
12’ SENTINEL STALL
FRONT LUMBER KIT
TARTERUSA.COM
For more information and questions, please contact:
Tarter Customer Service
1-800-RED-GATE 18007334283
Monday-Friday 800430 EST

KIT INCLUDES:
SLIDING DOOR
• 5 – 46-3/4” x 6-3/4” tongue and groove
• 1 – 46-3/4” x 6-3/4” groove only
• 1 – 46-3/4” x 5-3/4” groove only
STALL FRONT PANEL
• 3 – 36” x 6-3/4” tongue and groove
• 1 – 36” x 5-1/4” groove only
• 8 – 46-3/4” x 6-3/4” tongue and groove
• 1 – 46-3/4” x 6-3/4” groove only
• 1 – 46-3/4” x 2-3/4” groove only
REV2 09092110TYV014
STALL FRONT PANEL
1. Install 3 – 36” x 6-3/4”
tongue and groove boards.
Make sure groove is
towards the frame.
The first few boards can
be installed by leaning at
an angle and sliding in the
channel.
2. Install 1 – 36” x 5-1/4”
board, with groove only.
Board may need to be cut
to fit properly. Cut must be
made to the flat edge.
3. Install 8 – 46-3/4” x 6-3/4”
tongue and groove boards.
Make sure groove is
towards the flat edge of the
previous board.
4. Install 1 – 46-3/4” x 6-3/4”
board, with groove only.
Use notch to install final
boards.
5. Install 1 – 46-3/4” x 5-3/4”
board, with groove only.
Make sure the non-
grooved side is towards
the frame. Last board
may need to be cut to
fit properly. Cut must be
made to the flat edge.
6. Secure lumber with 4 -
#10 × 1” Phillip screws. It
is important to screw the
lumber in so the boards do
not come out. (Included in
stall hardware)
INSTALLATION NOTES:
• It is recommended to have the stall panel in its final location before
installing the lumber kit.
• Install Sliding Door first.
• The beveled edge of the boards must be facing outward and the
flat edge of the boards facing inward.
• A rubber mallet may be used to secure the boards tightly without
damaging them.
SLIDING DOOR
1. Install 5 – 46-3/4” x 6-3/4”
tongue and groove boards,
with groove towards the
frame. The first few boards
can be installed by leaning
at an angle and sliding in
the channel.
2. Install 1 – 46-3/4” x 6-3/4”
board, with groove only.
Use notch to install final
boards.
3. Install 1 – 46-3/4” x 5-3/4”
board, with groove only.
Make sure the non-
grooved side is towards
the frame. Last board
may need to be cut to
fit properly. Cut must be
made to the flat edge.
4. Secure lumber with 4 - #10
x 1” Phillips screws. It is
important to screw the
lumber in so the boards do
not come out. (Included in
stall hardware)
GROOVE TONGUE BEVELED EDGE
TOOLS NEEDED:
• Phillips Screw Driver
• Drill
• Rubber Mallet
• Tape Measure
• Circular Saw