Tascam US-1200 How to use

Latest versions and updates
The latest driver and firmware versions for these units are as follows.
Windows
Driver: 1.00rc2
Firmware: 1.00d1 (no new update)
Mac OS X
Driver: 3.01 (Now updated from version 3.00d18)
Firmware: 1.00 d1(no new update)
Always ensure that you are running the latest driver software and firmware by visiting TASCAM’s web site (http://tascam.com/).
Important Notice
Whenever updating drivers, previous drivers for this product should be uninstalled first.
Please turn on the unit (US-1200) after the computer is turned on.
Maintenance items
For Mac OS X Driver
Version 3.01
・A problem where the Meter display on the Mixer panel might stop working when the Mixer Mode was changed has been fixed.
・A problem where the computer audio would become garbled after the Mixer Mode was changed has been fixed.
・A problem where turning off the US-1200 while the Mixer panel was active would cause the computer to freeze has been fixed.
TASCAM US-1200 1
Firmware: 1.00d1,Windows Driver: 1.00rc2, Mac OS X Driver: 3.01
D01228420D
US-1200

Checking the driver and firmware versions
Check the current versions before beginning to update the US-1200 driver and firmware.
1. Press the MIXER PANEL button on the unit to open the Mixer Panel.
2. Click the “INTERFACE” tab to open the “INTERFACE” page.
3. Check the “Driver Version” and “Firmware Version” items on this page.
Windows US-1200 Mixer Panel
Mac OS X US-1200 Mixer Panel
2TASCAM US-1200
Firmware: 1.00d1,Windows Driver: 1.00rc2, Mac OS X Driver: 3.01
US-1200

How to install drivers
Follow the procedures below to install the latest driver.
Windows
Driver updating procedures
Before beginning installation, disconnect the US-1200 from
the USB cable. Before installing the new driver uninstall any
existing driver on the computer.
See “Uninstalling the driver” in the Owner’s Manual for
instructions.
1. Download the latest driver (Ver. x.xx driver) for your
operating system from the TASCAM website
(http://tascam.com/), and save it to your computer’s hard
disk.
2. Uncompress the driver zip file on the hard disk.
3. Double-click the “setup.cmd” file to start installation.
Follow the procedures in the Owner’s Manual to
complete the installation.
Mac OS X
Driver updating procedures
Before beginning installation, disconnect the US-1200 from
the USB cable. Before installing the new driver uninstall any
existing driver on the computer. See “Uninstalling the driver” in
the Owner’s Manual for instructions.
1. Download the latest driver (Ver. x.xx driver) for your
operating system from the TASCAM website
(http://tascam.com/).
2. Double-click the disc image file (.dmg file) you
downloaded, then double-click the “TASCAM
_US-1200_x.xx” file in the opened folder.
NOTE
There are times that the zip file you downloaded will
not be automatically unzipped depending on you
computer environment. In this case, double-click the
disc image file after unzipping the zip file.
3. After the installer launches, follow the instructions on
the screen to proceed with the installation.
4. Click the “Restart” button to quit the installer and
restart the computer.
TASCAM US-1200 3
Firmware: 1.00d1,Windows Driver: 1.00rc2, Mac OS X Driver: 3.01
US-1200