TATE FENCING Wiltshire arbour seat User manual

1280mm
670mm
Fix trellis between posts approx 75 -100 mm down from
top of posts using either 50mm screws if you have English
Rose trellis or 75mm screws if you have Square or Heavy
Diamond trellis. Fix where indicated with a symbol
Post are to be dug into ground approx 450mm
deep, at approx 670mm x 1280mm centres
450mm
1) 2)
tate
fencing
Wiltshire arbour seat
installation guide
Left Trellis
Right Trellis
Seat Rear
Seat Bottom
Rear Trellis
Arbour Top
4 x posts
Fixings included :-
Angled tops of posts go
at the top. With slants
arranged as shown here
4 x 75mm
6no
18no
5 x 100mm
Heavy diamond trellis option comes with
5 x 100mm
8no
To x trellis
To x roof
To x seat
4 x 75mm
6no
18no
5 x 100mm
Square trellis option comes with
5 x 100mm
8no
To x trellis
To x roof
To x seat
4 x 50mm
6no
18no
5 x 100mm
English Rose trellis option comes with
5 x 100mm
8no
To x trellis
To x roof
To x seat
The xings supplied vary depending on which trellis option you
have chosen for your Tate Fencing arbour seat :-
Parts supplied :-
75 - 100mm

The back seat rests on top of the frame of the bottom seat. It
leans backwards at an angle and the top of the seat frame ts
in between the rear posts. It is xed into place with 100mm
screws where indicated with a symbol. Screwing through
the bottom of the frame into the bottom seat frame. And
screwing through the top of the seat frame from the inside
in to the posts.
4)
5) 6)
Fix the seat bottom in between posts at desired sitting height.
Face x using 100mm screws where indicated with a
symbol. Screw from inside the arbour seat through the
frame in to the posts.
Fit the roof in place. The TGV boards rest on top of the posts.
The roof front and back frame is on the outside of the posts.
It is then secured with 100mm screws through the face of the
frame in to the posts where indicated with a symbol
3)
The roof comes in 2 sections which t together using 100mm
screws through the frame where indicated with a symbol