Taunotent TONNEAU COVER User manual

FITMENT INSTRUCTIONS
This fitment instruction applies to:
FORD FX4 WITH ROLLBAR
TONNEAU COVER
Clip on Tonneau cover fitment
instructions for Ford FX4 fitted
on edge of loadbin
Tool requirement for fitment:
Size 10 spanner or socket
4 bolts with washers
Tonneau kit comprises: 1 x clip on tonneau cover, 1x front aluminium
rail, 2 x long side rails with 2 clamps per rail, 2 x short side rails with 1
clamp per rail, 2 x back corners, 2 x support braces, 4 x brace holders,
4 x end caps.
Place front rail over the holes located on the front edge of the loadbin and using bolts fasten in place. If there is rub-
berising, use the rail as a marker to locate the holes. Using a blade, gently scrape the rubberising away to locate the
holes and then fit the rail.
Attach the two long side rails on either side of the loadbin using clamps to fasten into place.
Attach the two short side rails on either side of the load-
bin towards the back using one clamp per rail to fasten.
Insert the tailgate into the 2 small side rails using the
plastic corners. Tighten the screws on the corners.
Insert support braces into brace holders using the
stickers as reference.

FITMENT INSTRUCTIONS PAGE 2
Centre the cover at the tailgate and clip into rail and clip from the centre outward to the left and right sides. Then clip
into the side rails.
Warranty: The stitching is guarenteed for 6 months. Please only use Sunlight dish soap to wash the cover and
Dubbin to polish. All car wash products and polishes should not be used on the tonneau cover, as well as, high
pressure hoses and brushes.
WE THANK YOU FOR PURCHASING A TAUNOTENT PRODUCT
Slide the cover into the front rail.
FITTED COVER