Dakota Digital VHX-70C-CAM User manual

Manual #650370A
VHX-70C-CAM
Dakota Digital VHX Instrument Installation
For 1970-‘81 Chevy Camaro
Your new VHX-70C-CAM kit includes:
Installation
Control Box
CAT5 Cable
Universal Sender
Pack
Installation Manuals
VHX Display
1. First remove the four screws holding the bezel to the dash. These four screws will be re-used for the
VHX installation. If you wish to re-use the stock bezel, now is a good time to clean the bezel.
Switch Assembly

Manual #650370A
2. Remove the four screws holding the gauges into the dash. These screws will be re-used for the
VHX gauge installation.
3. Connect the CAT5 cable to the system. As the assembled cluster is installed into the dash, take care
when routing this cable to the control box.

Manual #650370A
4. Secure the VHX system to the dash with the original four screws.
5a. Remove the protective tape
from the clear lens and align the
bezel with the gauges. Watch
carefully as you align the bezel
so you don’t scratch or damage
the lens.
5b. The VHX system
should align tightly
and the lens should
sit flush with the
bezel.

Manual #650370A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
6. Secure the bezel to the dash with the four original screws. Refer to the main manual for wiring
instructions to complete the VHX installation.