Taxa Outdoors Woolly Bear User manual

STEP 1
•Keep trailer strapped to
pallet for safety
•Remove the tongue
assembly from the box stand
Tools Required:
•WD-40
•3/4” wrench
•3/4” socket wrench
•9/16” wrench
•5/32” allen wrench
Woolly Bear
Assembly Instructions
STEP 2
•Insert the tongue into the
main chassis
•Install two through bolts
with nuts on the sides.
(torque to 80 lb-ft)
•Install the black bolt on
bottom.
(flip the page for details)
STEP 3
•Rotate the tongue jack down
•Use the crank to raise the
jack. Remove the box stand
•Unstrap the trailer from
pallet and roll o pallet.
•Chock wheels
STEP 4
•Use 9/16” socket wrench for
nylocks, and 5/32” allen for bolts
•Install the risers in desired
position (Refer to diagram
for recommended riser
placement for weight
distribution.)
(flip the page for details)
page 1/2

Woolly Bear
Assembly Instructions
STEP 4 Detail
For each riser leg,
-Install two bolts from outside.
-Install two bolts from top plane.
-Tighten all nylocks until they are
well seated.
(See drawings)
nylocks inside
cargo deck
STEP 2 Detail
Installation of removable hitch.
- Remove 2 through bolts and nuts attached to removable hitch
- Remove single black bolt from bottom of removable hitch
- Use WD-40 to lubricate all 4 sides of removable hitch, then insert into the receiving hole
for hitch on the chassis. (Battery box facing up)
- Align holes on removable hitch with holes on the receiving end of the chassis.
- Insert through bolts with washer on both sides, and torque to 80 lb-ft using a ¾” ratchet
wrench and ¾” socket wrench.
-Tighten the black bolt until it is well seated.
page 2/2
through bolt
washer
nylock
washer
black bolt
nylock on bottom
of cargo deck
for 2 person tent
6-7 empty holes in
between risers
1 empty
hole
passenger
side view