Technica 820013 User manual

Wire shelving
instruction
Model:
820013, 820015
5.
Refer to the Step (3) to snap the plastic clips (E) on the same grooves of each pole at
your next desired position for other two pieces wire shelves. And then assemble other
two pieces wire shelves (A).
6.
Pushing firmly down on every wire shelf at corners by rubber mallet to ensure all the
wire shelves in a place over the plastic clips (E). And screw leveling feet in or out to
attain proper leveling.
4
Nr A B C D E F
Name Wire
Shelf Upper Pole Middle Pole Lower Pole Plastic Clip Leveling Feet
Pic.
Qty 4 PCS 4 PCS 4 PCS 4 PCS 32 PCS 4 szt
1
Technica Group spółka z ograniczoną odpowiedzialnością sp. k.
ul. Miłosna 2, 43-430 Ochaby Małe, tel.: [phone], www.sklep.technica.pl
E
B
A
E
D
C

ASSEMBLY INSTRUCTIONS
1.
Screw four pieces Leveling Feet (F) into the bottom of each Lower Pole (D). And snap
the Plastic Clips (E) on the grooves of each lower pole at the same position. Make sure
the arrow of all the plastic clips (E) should be pointed up.
3.
Refer to the Step (1) to snap plastic clips (E) on the grooves of four pieces lower poles
(D) at your desired position for next wire shelf. Slide down the next wire shelf (A) from
the top of each lower pole (D) down onto the plastic clips (E).
2.
Make sure that you have the Wire Shelf (A) the correct way up. Place the shelf on its
long side, hold and slide the top of four lower poles (D) through the bottom of each
shelf at its corners until there is snug fit. After the four poles have been slid through
the shelf collar holes, set the shelf upright.
4.
Screw Middle Poles (C) into lower poles (D) by screw connectors which are already
assembled on the middle poles (C). And then screw Upper Poles (B) into middle poles
(C) by screw connectors which are already assembled on the upper poles (B).
Plastic Clips’ arrow
shall be pointed up.
Keep the gap in collar face down.
3 ➡2