technoswitch CR135BI User manual

WALL MOUNTED DAILY PROGRAMMABLE THERMOSTAT

128 23
87

Fig.2
Fig.1

.

Installation
Factory Setting
Set time
MANUAL mode
AUTOMATIC mode
External Temperature Display
ON / OFF
Advanced Menu
Frost protection
Set Heating / Cooling
Operation with external probe
Correction of measured internal temperature
Correction of measured external temperature
Thermal differential
Advanced Menu Exit
Software Reset
8
11
12
13
14
17
18
19
21
23
24
25
26
27
28
29
INDEX
Firmware version 29

30
30
31
32
Replacement of supply batteries
Reset Hardware
Technical features
Safety warnings
9.
10.
11.
33
Information to users
12.
13.

in....
09

ASSEMBLY

Fig.6

saving the settings.
Fig.7 Fig.8
Fig.7
Fig.8

Fig.9
Fig.9

Es. If you want to have a 10 ° C Reduction temperature from 00:00 to 07:29 and a Comfort
temperature of 21.5 ° C from 07:30 to 23:59, you have to:
5.4.1 Set the Reduction temperature to 10 ° C using the left knob ;
5.4.2 Set the Comfort temperature to 21.5 ° C using the right knob ;
5.4.3 Move the switches down (0 / 7)
Move the switches upwards (7.30 / 23).
Fig.10

The display shows the outside temperature only if the external probe is correctly wired.
6.1 Press to display the temperature relative to the external / internal probe.
N.B.:
OUT (FIXED): outdoor temperature display.
OUT (FLASHING): regulates the switching on of the system through an external probe.
IN (FIXED): internal temperature display
IN (FLASHING): regulates the switching on of the system through an internal probe
If the external probe is interrupted or malfunctioning, the display will show the error message,
17
EXTERNAL TEMPERATURE DISPLAY6.0
Fig.11.
Fig.11.

7.1 Press to turn ON/OFF the system.
The display will show the symbol and the word OFF.
If the Frost Protection is active, the display will also show the icon .
(The icon is flashing if the Frost Protection threshold has been reached).
It’s important to avoid damage caused by too low temperatures.
To set the Frost Protection mode, see chapter 8.2.
18
ON / OFF7.0

8.1
8.2
8.0

8.0 ACCESS TO THE ADVANCED MENU
8.0.1 Hold down for 10 seconds until the icons appear on the display,
The selected icon flashes.
8.0.2 Press or and select the icon to be set.
8.0.3 Press OK to confirm.
8.0.4 Press + simultaneously to return to the advanced menu,
8.0.5 Press or until Esc appears. Press OK to confirm.
N.B. : After about 20 seconds of inactivity the device automatically exits the advanced
menu saving the modified settings.
20
Fig.12
Fig.12
Fig.12