TECHWOOD TRZ-939 User manual


RECHARGEABLE SHAVER
INSTRUCTION MANUAL
1

IMPORTANT SAFEGUARDS
❑Please read these instructions carefully before use.
❑Keep present instructions for future references.
❑Check that your mains voltage corresponds to that stated on
the appliance.
❑Keep the appliance dry.
❑This appliance contains batteries that are non-replaceable.
❑For the purposes of recharging the battery, only use the
detachable supply unit provided with this appliance.
❑Only use the appliance for domestic purposes and
household or similar applications such as:
-staff kitchen areas, in shops, offices and other working
environments;
-by clients in hotels, motels and other residential type
environments;
- Environment type like :
❑ • Farm Houses • Bed and Breakfast.
❑Only use the appliance in the way indicated in these
instructions.
❑Never use this unit near bathtub, shower, wash-hand basins
or other containers with water.
❑Never use this apparatus near water projections.
❑Never use this apparatus with the wet hands.
❑If, unfortunately the apparatus is wet, immediately withdraw
the cord of the socket-outlet.
❑Inform potential users of these instructions.
❑Never leave the appliance unsupervised when in use.
❑The appliance must be used only for its intended purpose. No
responsibility can be taken for any possible damage caused
by incorrect use or improper handling.
❑This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
2

mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved.
❑Children shall not play with the appliance.
❑Cleaning and user maintenance shall not be made by
children without supervision.
❑This device is not a toy, do not leave small children or people
with disabilities to play with.
❑In order to ensure your children‘s safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
❑Caution ! Do not allow small children to play with the foil :
THERE IS A DANGER OF SUFFOCATION !
❑From time to time check the cord for damages. Never use the
appliance if cord or appliance shows any signs of damage.
❑Never immerse the appliance in water or any other liquid for
any reason whatsoever.
❑Never place it into the dishwasher.
❑Never use the appliance near hot surfaces.
❑Disconnect the power source cable before any operation of
cleaning of maintenance and accessories assembly.
❑Never use accessories, which are not recommended by the
producer. They could constitute a danger to the user and risk
to damage the appliance.
❑The appliance is only to be used with the power supply unit
provided with the appliance.
❑The appliance must only be supplied at safety extra low
voltage corresponding to the marking on the appliance.
❑Never move the appliance by pulling the cord. Make sure the
cord cannot get caught in any way.
❑Never wind the cord around the appliance and do not bend it
3

❑Ensure that the power cord does not come into contact with
hot parts of this unit.
❑Make sure the appliance has cooled down before cleaning
and storing it.
❑The temperature of accessible surfaces may be very high
when the appliance is operating. Never touch these parts, of
apparatus, to avoid burning itself.
❑Make sure the appliance never comes into contact with
flammable materials, such as curtains, cloth, etc...& the
power cord and plug do not come in contact with water.
❑Before cleaning, always unplug the appliance from the power
supply and let it cool down.
❑This appliance is not intended to be operated by means of an
external timer or separate remote-control system.
❑Always place the unit on a flat surface. Ensure, also, not to
cover the device and not to put anything on it.
❑Always remove the plug from the wall socket when the
appliance is not in use.
❑When using an extension lead always make sure that the
entire cable is unwound from the reel. Use solely CE
approved extension leads. Input power must be at least 16A,
250V, 3000W.
❑Incorrect operation and improper use can damage the
appliance and cause injury to the user.
❑This device complies with standards relating to this type of
product.
(*) Competent qualified person : after sales department of the
producer or importer or any person who is qualified, approved
and competent to perform this kind of repairs.
GENERAL INFORMATION
4

The symbol "OPEN BOOK" means a recommendation
to read important things contained in the record.
The symbol "BIN" crossed out, abbreviation WEEE
(Waste of Electrical and Electronic Equipment) means
that at the end of life, it should not be discarded with
household waste, but filed to the sorting of the locality.
Waste recovery can help preserve our environment.
The symbol "CE" is the guarantee of compliance with
harmonized European standards, voluntary, reflecting
the essential requirements into technical
specifications. These standards are not mandatory
but are guarantees of compliance with essential
requirements.
The symbol ROHS (Restriction of use of some
Hazardous Substances) on the Environmental
Protection, certifies that for each of the five hazardous
substances • Lead • Mercury • (hexavalent) chromium •
products for protection against flames PBB and PBDE,
the peak concentration is equal to or less than 0.1% of
the weight of homogeneous material, and 0.01% for the
6th • cadmium.
The symbol "DOUBLE SQUARE" means a double
insulated. A basic insulation and supplementary
insulation. This device requires no connection to the
mass of a protective conductor grounded. The
materials are said : double insulation class II.
5

The symbol "TUB / SHOWER" crossed out means to
never use the unit in a bathroom, a shower in or near
water spray. (IP20 Minimum distance 3M.)
The symbol "TRIMAN" indicates that the consumer is
invited to dispose the product as part of a separate
collection (eg recycling bin, waste, voluntary intake
point).
For more information : http://www.quefairedemesdechets.fr
The symbol "CMIM marking" is the guarantee of compliance
with the harmonized Moroccan Standards, optional, which
translate the essential requirements into technical
specifications. These standards are not mandatory but
guarantee compliance with the essential requirements.
RECHARGEABLE SHAVER
TO KNOW HIS UNIT
1. Protective cover of the cutting blades
2. Micro stainless steel grid
3. Cutting heads (A - B - C)
4. Eject button of the shaver head
5. Body
6. On / Off switch
7. Charging indicator light
Charging
1. Push the switch down and close electrical power.
- The charging indicator is on, which shows that it is charging.
2. After 8 to 10 hours, charging is over.
3. At first using, be sure the battery is completely discharged, before charging,
which can durable the battery.
4. The shaver can be used for about 5 or 6 times for shaving.
Shaver
6

1. Take off the shelter and press the switch.
2. Softly touch your skin and move in the contrary growth
direction of beards slowly.
- If you stretch your skin tightly, you can obtain better effect.
3. Once the shaving is over, push the switch down at once and cover it with the
shelter.
NOTE: Charging time can’t exceed 15 hours or it affects the life of battery, even
damages the line.
Trimmer
1. Open the back cover and pull off the trimmer.
2. Softly touch your skin in the right-angle direction with the trimmer and trim
slowly.
3. After using, push down the switch and cover it with the shelter.
4. Press the switch and take off the shelter. Press the outer-cutter button and take
off the outer cutter. Clean the beards on the outer cutter, the inner cutter and
the body (1 time a week).
5. After cleaning, assemble the outer cutter and the inner cutter on the original
position and cover it with the shelter.
● Don’t press the net shelter.
● Don’t prizes open the net shelter with a screw with a screw driver.
● Do not change the positions of A B C heads and the directions of net cover
so as to avoid the affection to the normal operation of razor.
CLEANING AND MAINTENANCE
1. Remove the protective cover of the grid
2. Press the button (located under the head) to separate the shaver head and
body.
3. Also press the button on the back of the unit to remove the trimmer.
4. Remove the beard hairs with the brush provided and, if necessary, use a damp
cloth to clean the body.
5. After cleaning, reassemble the razor head with body in accordance with the
initial position and place the trimmer on the original position.
6. Replace the cover.
Before cleaning, always: switch off the appliance, disconnect the apparatus and
let it cool.
Clean the outside of the apparatus with a sponge or slightly wet linen.
Never plunge the apparatus in water or all other liquid!
Do not use abrasive cleaners, gritting, or metal brush or another cutting object.
STORAGE
7

-Ensure the unit is completely cool and dry.
-Do not wrap the cord around the appliance, as this will cause damage.
-Keep the appliance in a cool, dry place.
GUARANTEE
Before being delivered, all our products are subjected to a rigorous control.
This apparatus is guaranteed 24 months starting from the date of purchase of
consumer.
The documents in proof of guarantee are:
• The invoice and
• The filled and stamped warrantee plate (located on side or bottom of the gift
box). Without these documents in proof, no free replacement, nor no free repair,
can be carried out.
During the warranty period, we deal for free, the defects of the apparatus or the
accessories, rising from a defect of materials or manufacture by repair or,
replacement. The services within the framework of the guarantee do not involve
any extension of the warranty period and does not give right to a new guarantee!
In the event of recourse to the guarantee, bring back the complete apparatus to
your retailer, in its original packing, accompanied by the proofs of purchase.
The breakage of parts out of glass or plastic is, in all the cases, not warranted.
Defects on the accessories or the wearing parts (for example: coals of engines,
hooks, drive belts, remote control of replacement, teeth brushes of replacement,
webs etc) as well as cleaning, maintenance or it replacement of wearing parts are
not guaranteed and are thus to pay!
In the event of foreign intervention, the guarantee becomes null and void.
After flow of the warranty period, repairs can be carried out, against payment, by a
specialized trade or a repair service.
SPECIFICATIONS
Power supply 2,4Vd.c. / Ni-MH LR6 or AA - 600mAh battery
ADAPTER
Power supply Input : 100-240V~ 50/60Hz
Output : 3.0 V d.c. 1.0A 3.0W
Norm Class II
INFORMATION PUBLIEE
INFORMATION PUBLISHED
VALEUR ET PRECISION
VALUE AND PRECISION
UNITE
UNIT
MARQUE
BRAND
TECHWOOD
Sotech International
Commercial Registration Number/N°SIRET: 4250992000016
33 Avenue du Maréchal de Lattre de Tassigny
8

94120 Fontenay sous Bois - France
REFERENCE
MODEL IDENTIFIER
TRZ-939 – TRZ-956
Tension d’Entrée
Input Voltage
100-240
V
Fréquence du CA d’entrée
Input AC frequency
50/60
Hz
Tension de sortie
Output voltage
3.0
V
Courant de sortie
Output current
1.0
A
Puissance de sortie
Output power
3.0
W
Rendement moyen en mode actif
Average active efficiency
71.59
%
Rendement à faible charge (10%)
Efficiency at low load (10%)
-
%
Consommation électrique hors charge
No-load power consumption
0.052
W
The characteristics can change without preliminary preventing
For additional protection, the installation of a residual current device with a rated
residual operating current not exceeding 30 mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
CAUTION: In order to minimize the risks of electric shock, In the event of
breakdown, not to open the case but to call upon a qualified technician for repairs.
This apparatus satisfied EC directives, it was controlled according to all the
European current directives, like: electromagnetic compatibility (EMC) and low
tension (LVD).
This apparatus was designed and manufactured in respect of the last safety
regulations and technical specifications.
ENVIRONMENTAL PROTECTION (Destruction of Ni-MH or Ni-Cd batteries)
The appliance must be disconnected from the main power, when the battery is
removed.
• Disassemble the two parts of the unit and remove the battery.
- THE BATTERY MUST BE REMOVED BEFORE THE UNIT IS GIVEN TO
REBUS.
- THE BATTERY MUST BE ELIMINATED IN A SAFE WAY.
Imported by Sotech International
" LE PERIPOLE " N°A107
9

33, Avenue du Marechal de Lattre de Tassigny
94120 Fontenay sous bois - France

10