TECHWOOD TRZ-985 User manual


RECHARGEABLE SHAVER + NOSE TRIMMER
INSTRUCTION MANUAL
1

IMPORTANT SAFEGUARDS
❑Please read these instructions carefully before use.
❑Keep present instructions for future references.
❑Check that your mains voltage corresponds to that stated on
the appliance.
❑Only use the appliance for domestic purposes and
household or similar applications such as:
-staff kitchen areas, in shops, offices and other working
environments;
-by clients in hotels, motels and other residential type
environments;
- Environment type like : • Farm Houses • Bed and
Breakfast.
❑Only use the appliance in the way indicated in these
instructions.
❑Never use this unit near bathtub, shower, wash-hand basins
or other containers with water.
❑Never use this apparatus near water projections.
❑Never use this apparatus with the wet hands.
❑If, unfortunately the apparatus is wet, immediately withdraw
the cord of the socket-outlet.
❑Inform potential users of these instructions.
❑Never leave the appliance unsupervised when in use.
❑The appliance must be used only for its intended purpose. No
responsibility can be taken for any possible damage caused
by incorrect use or improper handling.
❑This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. 
2

❑Children shall not play with the appliance. 
❑Cleaning and user maintenance shall not be made by
children without supervision.
❑This device is not a toy, do not leave small children or people
with disabilities to play with.
❑In order to ensure your children‘s safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
❑Caution ! Do not allow small children to play with the foil :
THERE IS A DANGER OF SUFFOCATION !
❑From time to time check the cord for damages. Never use the
appliance if cord or appliance shows any signs of damage.
❑Never immerse the appliance in water or any other liquid for
any reason whatsoever.
❑Never place it into the dishwasher.
❑Never use the appliance near hot surfaces.
❑Disconnect the power source cable before any operation of
cleaning of maintenance and accessories assembly.
❑Never use the appliance outside and always place it in a dry
environment.
❑Never use accessories, which are not recommended by the
producer. They could constitute a danger to the user and risk
to damage the appliance.
❑Never use any other connector than the one provided.
❑Never move the appliance by pulling the cord. Make sure the
cord cannot get caught in any way.
❑Never wind the cord around the appliance and do not bend it
❑Ensure that the power cord does not come into contact with
hot parts of this unit.
❑Make sure the appliance has cooled down before cleaning
and storing it.
3

❑The temperature of accessible surfaces may be very high
when the appliance is operating. Never touch these parts, of
apparatus, to avoid burning itself.
❑Make sure the appliance never comes into contact with
flammable materials, such as curtains, cloth, etc...& the
power cord and plug do not come in contact with water.
❑Before cleaning, always unplug the appliance from the power
supply and let it cool down.
❑This appliance is not intended to be operated by means of an
external timer or separate remote-control system.
❑Always place the unit on a flat surface. Ensure, also, not to
cover the device and not to put anything on it.
❑Always remove the plug from the wall socket when the
appliance is not in use.
❑When using an extension lead always make sure that the
entire cable is unwound from the reel. Use solely CE
approved extension leads. Input power must be at least 16A,
250V, 3000W.
❑Incorrect operation and improper use can damage the
appliance and cause injury to the user.
❑This device complies with standards relating to this type of
product.
GENERAL INFORMATION
The symbol "OPEN BOOK" means a recommendation
to read important things contained in the record.
The symbol "BIN" crossed out, abbreviation WEEE
(Waste of Electrical and Electronic Equipment) means
that at the end of life, it should not be discarded with
household waste, but filed to the sorting of the locality.
Waste recovery can help preserve our environment.
4

The symbol "CE" is the guarantee of compliance with
harmonized European standards, voluntary, reflecting
the essential requirements into technical
specifications. These standards are not mandatory
but are guarantees of compliance with essential
requirements.
The symbol ROHS (Restriction of use of some
Hazardous Substances) on the Environmental
Protection, certifies that for each of the five hazardous
substances • Lead • Mercury • (hexavalent) chromium •
products for protection against flames PBB and PBDE,
the peak concentration is equal to or less than 0.1% of
the weight of homogeneous material, and 0.01% for the
6th • cadmium.
The symbol "DOUBLE SQUARE" means a double
insulated. A basic insulation and supplementary
insulation. This device requires no connection to the
mass of a protective conductor grounded. The
materials are said : double insulation class II.
The symbol "TUB / SHOWER" crossed out means to
never use the unit in a bathroom, a shower in or near
The symbol "TRIMAN" indicates that the consumer is
invited to dispose the product as part of a separate
collection (eg recycling bin, waste, voluntary intake
point).
For more information : http://www.quefairedemesdechets.fr
5

6

RECHARGEABLE SHAVER
TO KNOW HIS UNIT
1. 3 Cutting heads
2. Micro stainless steel grid
3. Eject button of the shaver heads
4. Comfort handle
5. On / Off switch
6. Charging indicator light
Shaver
1. Take off the shelter and push up the switch.
2. Softly touch your skin and move slowly, in the contrary growth direction of
beard.
Note : If you stretch your skin tightly, you can obtain better effect.
3. Once the shaving is over, push the switch down at once and cover it with the
shelter.
NOTE : Charging time can’t exceed 15 hours or it will affect the life of the battery.
Charging
1. Push the switch down and close electrical power.
- The charging indicator is on, which shows that it is charging.
2. After 12 hours, charging is over. Charging power is 230V~ 50Hz.
3. At first using, be sure the scored power is completely out, before charging,
which can durable the battery.
4. The shaver can be used for about 5 or 6 times for shaving.
Trimmer
1. Open the back cover and pull off the trimmer.
2. Softly touch your skin in the right-angle direction with the trimmer and trim
slowly.
3. After using, push down the switch and cover it with the shelter.
4. Press the switch and take off the shelter. Press the outer-cutter button and take
off the outer cutter. Clean the beards on the outer cutter, the inner cutter and
the body (1 time a week).
5. After cleaning, assemble the outer cutter and the inner cutter on the original
position and cover it with the shelter.
● Don’t press the net shelter.
● Don’t prizes open the net shelter with a screw with a screw driver.
● Do not change the positions of A B C heads and the directions of net cover
so as to avoid the affection to the normal operation of razor.
7

Maintenance
1. Remove the protective cover of the grid
2. Press the button (located under the head) to separate the shaver head and
body.
3. Also press the button on the back of the unit to remove the trimmer.
4. Remove the beard hairs with the brush provided and, if necessary, use a damp
cloth to clean the body.
5. After cleaning, reassemble the razor head with body in accordance with the
initial position and place the trimmer on the original position.
6. Replace the cover.
NOSE TRIMMER
● Only the blade unit and INNER/OUTER blades should be cleaned.
● Keep motor and battery dry.
● Dry the blades before replacing.
Special safety instructions
*Do not insert the device further than the thin tip of the shearing blade up your
nose!
*Do not use the device if the shearing blade holder, the shearing blade or the
inner blade are distorted or damaged! DANGER OF INJURY!
*This device is to be used exclusively for the cutting of nose and ear hair!
Do not use the device any other purpose!
*The shearing blade and the inner blade are precision-manufactured.
Do not exert heavy loads on it and avoid knocking!
*Keep the device away from humidity and liquids!
*Do not remove the shearing head during use! Switch off the device and remove
the battery before cleaning!
*Do not insert pointed objects in the shearing head.
Putting into Service
1. Take the protection cap off the shearing head.
2. To switch on the device shift the on/off switch towards the shearing head.
3. Insert the tip of the shearing head in your nose.
Warning: Remove only the hair coming out of your nose and do not press the device
inwards! Do not insert the shearing head too deep and forcefully into your
nose: risk of injury!
4. If pieces of hair remain in your nose after cutting, remove these simply by
clearing your nose.
CLEANING AND MAINTENANCE
8

● Before cleaning switch the device off with the on/off switch.
● Always disconnect the apparatus and to let it cool before cleaning.
● Clean the outside of the apparatus with a sponge or slightly wet linen.
● Never plunge the apparatus in water or all other liquid !
● Do not use abrasive cleaners, gritting, or metal brush or another cutting object.
● Take the cleaning brush.
● Turn the shearing head to the left to loosen it and then pull it out.
● Pull out the shearing blade with caution.
Warning: the cutting blade is sharp! DANGER OF INJURY!
● Brush the shearing head and clamp in a star-shaped manner. Remove even the
smallest bits of hair by blowing.
● Mount the shearing head back on the drive shaft of the device and screw it on
turning to the right.
● After cleaning store the cleaning brush.
● Push the protection cap back on the shearing head.
STORAGE
-Ensure the unit is completely cool and dry.
-Do not wrap the cord around the appliance, as this will cause damage.
-Keep the appliance in a cool, dry place.
GUARANTEE
Before being delivered, all our products are subjected to a rigorous control.
This apparatus is guaranteed 24 months starting from the date of purchase.
The documents in proof of guarantee are :
• The invoice and
• The filled and stamped warrantee plate (located on side or bottom of the gift
box). Without these documents in proof, no free replacement, nor no free repair,
can be carried out.
During the warranty period, we deal for free, the defects of the apparatus or the
accessories, rising from a defect of materials or manufacture by repair or,
replacement. The services within the framework of the guarantee do not involve
any extension of the warranty period and does not give right to a new guarantee !
In the event of recourse to the guarantee, bring back the complete apparatus to
your retailer, in its original packing, accompanied by the proofs of purchase.
The breakage of parts out of glass or plastic is, in all the cases, not warranted.
Defects on the accessories or the wearing parts (for example: coals of engines,
hooks, drive belts, remote control of replacement, teeth brushes of replacement,
webs etc) as well as cleaning, maintenance or it replacement of wearing parts are
not guaranteed and are thus to pay !
9

In the event of foreign intervention, the guarantee becomes null and void.
After flow of the warranty period, repairs can be carried out, against payment, by a
specialized trade or a repair service.
10