TecScan FUNcaster Barometer User manual

Custom Settings
Press BAR to choose Time or
Barometer
Press DOWN to choose
Fahrenheit or Celsius
Press UP to choose Barometric
Unit, inHg or hPa/mb.
Important Details
a) Removing batteries resets to Factory
Default settings.
b) To test temperature accuracy, place unit on
plastic or wood, near your home’s HVAC
thermostat for about 4 hours.
c) Adjusting barometer will not affect 8-12
hour weather outlook calculation.
d) If FUNcaster becomes wet, promptly
remove batteries, pat dry, and place in warm
dry area for 48 hours. Restart as usual.
To Install FUNcaster ®
A. Remove battery cover (Note polarity)
insert 2 AAA batteries. Replace cover.
B. Install out of direct sunlight, high and
away from dark colors, protected from
rain and spray as possible.
C. Fully clean location surface before
attaching with nylon fastener.
FUNcaster ®Barometer
Range of Data Displayed:
Temperature: 32oF/0oCto 140oF/60oC
Lo = temps below 32oF/0oC
Hi = temps above 140oF/60oC
Humidity: 10 % to 99 %
Barometer: 23.62 to 32.48 inHg, hPa/mb
NOAA RAIN (%) GUIDE
10 or 20%: ISOLATED SHOWERS
30, 40, or 50%: SCATTERED SHOWERS
60 or 70%: SHOWERS LIKELY
BAROMETRIC ALGORITHM
8-12 HOUR OUTLOOK
HELP: 1-352-264-7877 or [e-mail]
WEBSITE: hps://store.tecscan.com HELP: 1-352-264-7877 or [e-mail]
WEBSITE: hps://store.tecscan.com

For Settings Use
1. L-o-n-g Press SET until Hour Blinks
2. Press Up/Down to Set Hour
3. Press SET
4. Press Up/Down to Set Minutes
5. Settings save after 20 seconds
Optional Temp or Barometer Offset
Always observe your FUNcaster a few days
before making adjustments.
1.L-o-n-g Press SET until Hour Blinks
2.Press SET - Minutes Blink
3.Press SET - Temperature Blinks
4.Press UP/DOWN - for Temp Offset
5.Press SET - Barometer Blinks
6.Press UP/DOWN - for Barometer Offset
7. Settings save after 20 seconds
8-12 Hour Weather OUTLOOK
FUNcaster ®requires me to learn area barometric pressure
patterns for the most accurate 8-12 hour weather outlook.
BUTTONS