DISCLAIMERS
1. This product must be installed and used as
per these instructions.
2. This product contains no serviceable
parts and no attempt should be made to
repair this product. If the product is faulty it
should be discarded.
3. This product is not suitable for installation
in hazardous and/or corrosive areas.
4. Electrical installations periodically receive
transient over voltages. This product has
been designed to minimise the eect of
such voltages on connected equipment.
It may not give full protection for extreme
over-voltage transients such as those
resulting from a close lightning strike.
5. This product utilises intellectual property in
the form of registered designs, trademarks,
and/or patents. Such intellectual property
remains the property of Teknik Lighting
Solutions Pty Ltd in all cases.
> True 10-year warranty
> Ecacy up to 180lm/W
> Low glare UGR<25
> Durable design
> Unique design to reduce dust build up
Thank you for selecting the [PRIME] GEN 3 LED HIGHBAY. Please ensure that the luminaire is installed
in accordance with the below instructions. Teknik Lighting Solutions Pty Ltd assumes no responsibility
for inappropriate use or installation of the product, including any associated damage caused.
Features:
INTRODUCTION
1. Read the entire manual carefully prior to
installation and operation.
2. The warranty period is listed on the product
as well as on the packaging. Teknik will
repair or replace the product if it becomes
defective under normal use due to a
manufacturing defect within the prescribed
period.
3. Declared lumen output is based upon
measurements obtained during operation
on the appointed LED electronic driver
under standardised laboratory conditions.
4. Installation must be performed by a
licenced and qualified electrician, in
accordance with these instructions and
relevant Australian Standards.
5. Instant restart is allowed.
6. Do not change or tamper with any internal
electric circuits, add any wires, connectors
or cables for any reason.
7. Please do not insert any physical objects of
any nature into the fitting as this may cause
electric shock, malfunction or damage to
the products.
8. Before replacement of the fitting turn the
power o and allow to cool down.
9. In case of weight discrepancy when
replacing old lamps, please ensure that
the mounted structure is rated to withstand
the weight of the new lamp and installation
materials.
10. For further information, please contact
Teknik (www.tekniklighting.com.au) or your
local distributor.
PRECAUTION
2
www.tekniklighting.com.au
