Tekon PLUS WRP001 User manual

PLUS WRP001
INSTALLATION GUIDE
TEKON ELECTRONICS AVEIRO, PORTUGAL
P.: [phone] M.: [phone] E.: [email protected]
IG_PLUS_WRP001_E01A
PLUS WRP001PLUS WRP001
INSTALLATION GUIDEINSTALLATION GUIDE

2
DUOS WIRELESS SYSTEM INSTALLATION GUIDE
01
step WRP001 PLUS WIRELESS REPEATER CONFIGURATION
Pages 2 to 8
02
step SITE SURVEY MODE
Pages 9 to 10
PLUS WRP001 WIRELESS REPEATER
INSTALLATION GUIDE
Table of contents

01
step
WRP001 PLUS WIRELESS REPEATER CONFIGURATION

4
PLUS WRP001 INSTALLATION GUIDE
01
step
CONNECT AND CONFIGURE THE PLUS WIRELESS REPEATER
01 Loosen the 4 screws of the case and oppen it.
03 Open a new window of Tekon Configurator Software and select PLUS >> Repeater menu.
2
1
02 Connect a micro USB cable to the computer
and then to WRP001 PLUS Wireless Repeater.

01
step
CONNECT AND CONFIGURE THE PLUS WIRELESS REPEATER
5
INSTALLATION GUIDE PLUS WRP001
05 Select corresponding Port name1.
04 Click on Rescan Ports button.
1You can check device’s serial port name in “Device Manager” on Microsoft® Windows® operating system.

6
PLUS WRP001 INSTALLATION GUIDE
01
step
CONNECT AND CONFIGURE THE PLUS WIRELESS REPEATER
06 Click on Configuration Mode ( ) button.
( ) button.
ANALOG WIRELESS TRANSMITTER
WIRELESS REPEATER
LED
permanently
on
LED
permanently
o 
LEDs flashing
until wireless
connection is
established

01
step
CONNECT AND CONFIGURE THE PLUS WIRELESS REPEATER
7
INSTALLATION GUIDE PLUS WRP001
07 Configure Wireless Network ID and Wireless Channel previously obtained from Gateway.
Click on Write button to update Transmitter settings.
08 Click on Configuration Mode ( ) button to exit setup and resume normal operating mode.
( ) button to exit setup and resume normal operating mode.

8
PLUS WRP001 INSTALLATION GUIDE
01
step
CONNECT AND CONFIGURE THE PLUS WIRELESS REPEATER
ANALOG WIRELESS TRANSMITTER
Connection to the Gateway
not established
WIRELESS REPEATER
LED
permanently
on
LED
permanently
o
LEDs flashing
until wireless
connection is
established
Connection to the Gateway
established

02
step
SITE SURVEY MODE

10
PLUS WRP001 INSTALLATION GUIDE
02
step
SITE SURVEY MODE
Site survey mode is a tool that allows a quick wireless signal strength evaluation at the site of installation. It
doesn’t require additional equipment or software.
This feature is available in all the transmitters and repeater from PLUS Product Family.
01 Press and hold Mode ( ) button untill Status LEDs are permanently on and Mode LEDs flash.
RSSI LEDs indicate the signal strength.
RSSI communication level
LOW
MEDIUM
GOOD
EXCELLENT
Connection to the Gateway established
ANALOG WIRELESS TRANSMITTER
LED
permanently on
LED flashing
until wireless
connection is
established
WIRELESS REPEATER
02 Press and hold Mode ( ) button untill RSSI LEDs switch o and device resumes normal operation mode.
Connection Lost