TekTone Tek-CARE NC554/8 User manual
www.tektone.com
Phone: 828.524.9967 • Fax: 828.524.9968 • Sales: Choose option 2 • Tech Support: Choose option 3
TekTone’s quality system is registered by DQS to the ISO 9001:2015 standard. (Reference
#10001510.)
NC554/8 Network Switch
IL954 Installation Instructions
Tek-CARE®Nurse Call Systems • Rev. 3– 11/2019
Introduction
TheNC554/8 8-port network switch is used to build
the Tek-CARE® Network. This network provides faster
data transmission and enables some ancillary features
that are too data intensive for just one CE connection.
These fast Ethernet switches automatically detect the
type of network (auto negotiation) and type of cable (auto
NC554/8 8-port Network Switch
Ethernet devices to the Tek-CARE Network.
Package Contents
• These Installation Instructions
System Requirements
• Available AC electrical outlet
•
•Gen2 ms
•
•
Installation
Refer to Figure 1 during installation.
(such as a desktop) or be securely mounted to a wall or
2. The centers of the two mounting sockets on the back of
the drilling guide in Figure 2
the
3.
tools and hardware to install mounting screws into the
mm) between the head of the screw and the wall surface.
4.
the case downward so that the screw heads slide into
the narrow slots.
5. the
Ethernet port on the rear panel of the network switch.
the networkdevice. Repeat foreachadditional network
device you wish to connect to the network switch.
6.
on the top of the switch should now be lit.
7.
-
Troubleshooting
Power LED does not light up:
• Check the connection of the power adapter into the
network switch and electrical outlet.
outlet.
Port Activity LED indicator does not light up when
connected:
to make sure it is properly plugged in.
• Try switching the ends of the cable.
• Make sure the network device is powered on and
the network interface is enabled on it (check the
network device’s documentation).
• Connect the Ethernet cable to a different port on the
network switch.
• Replace the Ethernet cable with a different cable.
Page 2 • IL954 NC554-series Installation Instructions Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
FCC Compliance Statement
This equipment has been tested and found to comply with
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
Figure 2—Drilling Guide
• Connect the equipment into an outlet on a circuit
different fromthat towhichthe receiveris connected.
• Consult the dealer or an experienced radio/TV tech-
nician for help.
Figure 1—NC554/8 Network Switch
8.825 cm (3.475")
Table of contents
Other TekTone Switch manuals
