5
Instruction manual
5
Program mode
• Up to 20 CD tracks or 99 MP3 tracks
can be programmed for disc play in any
order, including one and the same track.
Before use, be sure to press STOP button.
• Press PROGRAM button, the
memory position number will show on the
display.
• Select a desired track by using BACK
and NEXT buttons.
• Press PROGRAM to confirm.
• Repeat the two last steps as
described above to enter additional
memories into the program if necessary.
• When all the desired tracks have
been programmed, press PLAY/PAUSE/
USB button to play the disc in the order
you have programmed.
• To stop the CD, press STOP button.
The program memory will be cleared
only when the CD compartment is opened
or turn off the CD or power supply.
• To turn off the CD player set
FUNCTION switch to OFF position.
Good quality sound is guaranteed
only when playing licensed discs.
USB operation
• This unit is equipped with a USB
socket which can accept and play MP3
files stored on standard USB flash
(compatible with USB version 1.1 & 2.0)
up to 16 GBs.
• To use USB drives for MP3 playback
insert the USB drive into the USB-port
and slide FUNCTION switch to CD/MP3/
USB position. Press and hold PLAY/
PAUSE/USB button to enable USB mode;
the display will show “USB”.
• If MP3 files are found the set will start
playback of the first file.
• Playback control is same as for MP3
discs.
Always switch off the unit or
change mode to “CD” or “RADIO” before
removing a USB flash drive to prevent
damage to your USB device.
Attention: Although this product is fully
compatible with USB 1.1 & 2.0 standard
formats, a small percentage of USB flash
drives might not be readable, due to those
device manufacturers non-compliance
with the full (official) USB standards.
AUX line in jack
You can connect the audio output of
an external device (such as a CD-player)
to this unit, to listen to the sound of that
device through the amplifier of this unit.
• To connect an external audio device
(eg. MP3 player), please use a standard
stereo cable (not included) with 3.5 mm to
3.5 mm plugs to connect the headphone
out or audio line-out of the external device
to the AUX input socket of this unit.
• Slide the function switch to AUX
position.
• Turn on the external device.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced.
If the unit is not going to be used for some
time or is being run exclusively on the
alternative power, remove the batteries to
avoid leakage and damage.
• Electronic products of this kind
