Telemotive AN102-0 User manual

AN102-0 Remote Antenna Kit For TeleMotion 3.2
Installation Guide
Internal
antenna
E10197-0
RF
Receiver
A13151-0
Filter
E10196-0
TeleMotion 3.2 Receiver
Remove filter
Remove internal antenna
With a small blade screwdriver pry off above, units are held with double stick tape
TC102-0 Rev A. 1

AN102-0 Remote Antenna Kit For TeleMotion 3.2
Installation Guide (Continued).
Unsolder cable
connection to filter
b
oard. Marked “IN”.
Solder Remote Antenna Adapter cable to
filter cable connection point marked “IN”.
N
ote that shield braid goes closest to the
word “IN”. See diagram below.
IN
OUT
Shield braid Center conductor
Solder
Remote Antenna
Ada
p
ter cable
Remote Antenna
Adapter
WA12030-3
Filter Board
2

AN102-0 Remote Antenna Kit For TeleMotion 3.2
Installation Guide (Continued).
1.
3. DO NOT
ADJUST OR
ATTEMPT TO
TUNE.
2.
1. Drill ½” hole where needed.
Make sure cable is long enough to reach hole.
Try to keep as far away as possible from motor or power wiring.
Remove nut from antenna connector and insert antenna connector in hole.
2. Stick filter board back to top housing.
3. Dress wires as close to RF Receiver as possible and away from motor and power lines.
Install nut
and tighten.
Installation complete no tuning or
adjustments necessary. Do not forget
to install external antenna.
3