Teltex GLT User manual

Teltex
GLT Captioning Tablet
with V2T-10
Quick Setup Guide
Step 3.
Connect the 3.5mm Stereo Audio Cable from the Geemarc V2T-10 to
the Android Tablet. Connect the Tablet Power Cable from the
Android Tablet charging port to the Tablet Power Supply. Then
connect the Tablet Power Supply to an Electrical Outlet.
Step 4.
Turn on the Geemarc V2T-10 and set to “Auto” position.
Step 5.
Turn on the tablet by holding down the On/Off button for 5 seconds.
Step 6.
Start using your Teltex GLT Tablet to caption all of your calls.
Electrical
Outlet
Tablet
Power Cable
Tablet
Power Supply
Android Tablet
3.5mm Stereo
Audio Cable
Short Line Cord
Handset
Curly Cord
Geemarc
V2T-10
Home Phone
For Setup Videos Visit:
https://www.iaccessibility.com/videos/deaf-hard-of-hearing/

Step 1.
Install 9-volt battery into V2T-10 unit and connect the V2T-10 unit to
telephone as shown below.
Step 2.
Connect the WiFi Power Cable to the WiFi Power Supply, then con-
nect it to an Electrical Outlet. Connect the WiFi Power Cable to the
Mini WiFi Router Power jack.
Next, connect the Ethernet Cable to the WAN port on Mini WiFi Rout-
er and connect the other end of the Ethernet Cable to your Internet
Router (not included).
Short Line Cord
Handset
Curly Cord
Geemarc
V2T-10
Home Phone
AA
What’s in the Box:
(A) Geemarc V2T-10
(B) 9-Volt Battery
(C) Short line cord
(D) 3.5mm Stereo Audio Cable
(E) Android Tablet
(F) Tablet Power Supply
(G) Tablet Power Cable
(H) Mini WiFi Router
(i) WiFi Power Supply
(J) WiFi Power Cable
(K) Ethernet Cable
(L) Tablet Stand
D
C
i
J
K
H
L
G
E
F
A
B
Mini WiFi Router
WiFi
Power Cable
Electrical
Outlet WiFi
Power Supply
Internet Router
(not included)
Ethernet Cable