Teltonika Inateck BCST-70 User manual

https://wiki.teltonika-gps.com/view/Inateck_BCST-70_First_Start
Inateck BCST-70 First Start
Main Page > Accessories > Inateck BCST-70 Barcode Scanner > Inateck BCST-70 First Start
Contents
1 Inateck Barcode Scanner Configuration
1.1 Configure Scanner to use Enter as Suffix
1.2 Configure Scanner to SPP Mode
Inateck Barcode Scanner Configuration
Configure Scanner to use Enter as Suffix
Power on Inateck BCST-70 by toggling switch from OFF to ON.
IMPORTANT NOTE : Inateck Scanner could not scan Barcodes through screen/monitor, barcodes
should be printed as hard copy to proceed on the configuration.
Scan the "Enter Setup" barcode1.
Scan the "Apply Enter as Stop Character" barcode2.
Scan the "Exit with Save" barcode3.
Configure Scanner to SPP Mode
BCST-70 has Bluetooth capability that supports data transmission under HID and SPP two modes.
When under HID mode, the BCST-70 connects your phone or computer automatically after pairing
successfully. When under SPP mode, the BCST-70 can only finish connecting your phone or laptop
with help of serial debugging tools after pairing successfully. For connection with Teltonika FM
devices, scanner must use SPP Mode.
IMPORTANT NOTE : If scanner does not use SPP mode, Teltonika FM device would not detect the

scanner under the Bluetooth tab
Scan the "Enter Setup" barcode1.
Scan the "Apply Enter as Stop Character" barcode2.
Scan the "Exit with Save" barcode3.