Testrite Visual Charisma Cabinet Frame XCAB Series User manual

Page 1 of 2Version: 2
1. Insert the corner bracket into the slot of one frame side as shown. Using the hex key provided, loosely tighten one screw so the
bracket does not slip out. Attach the next bracket pair to the opposite end of the same frame same.
2. Repeat step 1 for the opposite frame side
3. Insert the brackets of the one frame side into frame sides without brackets. Repeat for opposite frame side. Fully tighten all screws.
4. Mount the frame to the cabinet structure, using screws and anchors appropriate to your environment. Ensure frame is well secured
and supported on all 4 sides, as graphic will pull on frame.
5. Install the graphic per the instructions on the next page.
Charisma Cabinet Frame™ - XCAB Series
XCAB1824 shown
3.
5.4.
1.
2. 1.
1.
3.
3.
3.
3.2.
2.
5.
Mount to
cabinet using
screws, ensure
frame is well
secured

Page 2 of 2Version: 2
1. To install the graphic, take the corner with the pull tag on it and press about 6”-10”of silicone into the frame channel corner A. Repeat
for the opposite corner B. Repeat for the next corner C. Lastly, repeat for the nal corner D.
2. After all corners are pressed in, press the silicone into the frame channel at the mid-points on all four sides.
3. Press silicone into frame evenly between the corner and midpoints.
This prevents the graphic from bunching up or stretching too much and will ensure a smooth and tight t.
4. To remove the graphic from the frame, simply pull up on the pull tag.
Charisma Cabinet Frame™ - XCAB Series
XCAB1824 shown
3.
1. 2.
3.
pull tag
4.
pull tag
A
B
C
D