Texsport Boulder Creek Vestibule Tent User manual

INSTRUCTIONS
Item 01112
Boulder Creek Vestibule Tent
Thank you for purchasing this Texsport tent. Please read and understand each step of the set-up instructions. We encourage you to set-up this tent
at least once prior to your camping trip, ensuring that you have a satisfactory understanding of the set-up process. We hope you enjoy your new
tent and that it will give you many years of camping pleasure.
Do not apply excessive force to this product.
PARTS LIST:
A......Tent skin
B......1 fly pole
C......4 sets of tent poles
D......Stakes, guy ropes and clews
NOTE:
Prepare your camp site by removing all sharp
stones, twigs, etc. The site should be flat and have
no depressions that could collect rain water.
A
B
C
D
STEP 1 - Spread out tent skin. STEP 2 - Assemble the tent poles
(C) and insert through the tent
sleeves.
STEP 3 - our poles should form
double X as shown above.
STEP 5 - our tent poles should
cross at the sides.
STEP 4 - Insert the pin and ring
into the tent poles.
STEP 6 - our roof poles should
form 2 large X’s.
STEP 7 - Secure skin by snapping
all speed clips onto the outer most
tent pole.
STEP 8 - Stake down at the ring. STEP 9 - Spread out the fly bottom
side up.

STEP 12 - Secure fly to tent with
attached buckels. Pull or loosen
web straps to adjust tension.
STEP 13 - Stake out the vestibule. STEP 14 - Stake out the mud mat
at the 2 corners.
STEP 12 - Drape assembled fly
over tent and insert the pin and
rings into the fly pole.
STEP 11 - Secure pole to fly with
attached velcro.
STEP 10 - Assemble the fly pole (B)
and push through the sleeve.
STEP 15 - It is recommended in
windy weather to secure your tent
with guy ropes. Insert the guy
rope into clew as shown above.
STEP 16 - Tie the other end of the
guy rope to the tabs on the fly.
STEP 17 - Loosen the guy rope as
shown to wrap around a stake.
STEP 18 - Stake down the guy
rope.
STEP 19 - Adjust the tension on the
guy rope by sliding the clew up or
down.