TFS Firechief Sitewarden SC400RF User manual

3 Lands End Way
Oakham
Rutland U.K.
LE15 6RB
Phone: [phone]
Email: sales@rechiefglobal.com
www.rechiefglobal.com
QUICK START GUIDE
The Sitewarden SC400RF manual call point is designed to be used
within the Sitewarden RF re alarm system. It provides the user with
the exibility to install radio linked manual call points in the ideal
locations required for your system.
All Sitewarden SC400RF are required to be paired to a SP400RF.
Using the instructions provided with the SP400RF Fire Alarm, please
set up the MASTER unit rst and then proceed with the pairing of
the SC400RF manual call point, by following the steps overleaf.
SC400RF
Radio Linked Resettable Manual Call Point
Phone: [phone]
Email: sales@rechiefglobal.com
www.rechiefglobal.com

Phone: [phone]
Email: sales@rechiefglobal.com
www.rechiefglobal.com
Radio Linked Resettable Manual Call Point
1. Remove the screw from the front of the
manual call point and carefully remove the
call point from the base/back box.
2. Insert the batteries supplied observing
the polarity indicated – you will hear
a short series of beeps, followed by
three dual tones which indicates that
the system is now ready to operate.
3. With the manual call point near to the
MASTER site alarm, press and release the
PROG button on the back of the call point
unit.
SC400RF
PAIRING A SC400RF CALL POINT
4. A number will appear on the LED
display on the front of each unit and
you will hear a conrmation tone from
each. The number is the address of that
SLAVE unit.
5. The units are now paired. Further
SC400RF units can be added to the
system, up to a total of 10 including
the master unit.
6. Mount the call point base in the desired
location using suitable xings and
replace the call point cover and screw.