The Land of Nod Taylor Armoire User manual

The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
This page lists the contents included in the box. Please take
time to identify the hardware as well as the individual
components of the product. As you unpack and prepare for
assembly, place the contents on a carpeted or padded area
to protect them from damage. Please follow the assembly
instructions closely. Improper assembly can result in
personal or property damage.
Note: 2 adults are required to safely assemble this product.
WARNING:
CHOKING HAZARD - SMALL PARTS
Small parts present in unassembled state.
Adult assembly required.
Taylor Armoire Assembly Instructions
Page1 of 4Made in Vietnam - r02
NOT INCLUDED
x04 x04 x04
x04 x02
x01

1
2
Taylor Armoire Assembly Instructions
Made in Vietnam - r02
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Page2 of 4
*hardware and
shelf supports
are pre-attached

WARNING
Serious or fatal crushing injuries can occur from furniture tipover. To help prevent tipover:
• Install all tipover restraints provided with your product
• Place heaviest items in the lower drawers
• Do not set TVs or other heavy objects on top of this product
• Never allow children to climb or hang on drawers, doors, or shelves
• Never open more than one drawer at a time
Use of tipover restraints may only reduce, but will not eliminate, the risk of tipover.
Safety Mounting Instructions:
1. Using a screwdriver and screws provided, secure mounting plate(s) to the back of the product.
2. While making note of the product location and the location of the product's anti-tip mounting plate(s), mark on the wall
the position for pilot holes for the wall mounting plate(s).
3. Drill pilot holes into marked positions and into a wall stud; note if a wall stud(s) is not available, drill holes slightly smaller
than drywall anchor and insert each anchor until flush with the wall.
4. Using a screwdriver and screws provided, secure mounting plate(s) to the wall stud or drywall anchors.
5. Position product in final location, and secure to the wall by lacing one end of plastic tie(s) through both the wall and
product mounting plates, and through the other end of the tie, pulling tightly to remove slack.
!
Taylor Armoire Assembly Instructions
Made in Vietnam - r02
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Page3 of 4

Taylor Armoire Assembly Instructions
Made in Vietnam - r02
The Land of Nod
8135 River Drive • Morton Grove, IL 60053 • p: [phone] • e: [email protected] • www.landofnod.com
Page4 of 4
Depth adjustment:
Loosen screw A, push hinge arm
forwards or backwards, re-tighten
screw Aand secure screw Bwith
a 1/4 turn clockwise
Height adjustment:
Loosen screw C, adjust door
height and re-tighten screw C
A
B
123
Side to side adjustment:
Loosen screw A, adjust gap with
screw Band re-tighten screw A
AC
C
B
HINGE ADJUSTMENT
If the doors do not appear square or aligned, loosen or tighten the appropriate screws on each case hinge as illustrated: