Theodoor FM-4010-L/Y S6 User manual

AIR CURTAIN
INSTALLATION MANUAL
Thanks for purchasing thisAir Curtain,
please read these instructions carefully before use.

1、IDENTIFICATION & INSTALLATION DIMENSIONS
MODEL A B C D E F G H
FM-4009-L/Y S6 900 --- 695 ---
100 85 240 220
FM-4010-L/Y S6 1000 --- 695 ---
FM-4012-L/Y S6 1200 295 990 ---
FM-4015-L/Y S6 1500 504 1285 ---
FM-4018-L/Y S6 1800 210 885 1580
FM-4020-L/Y S6 2000 210 885 1580
2、INSTALLATION CAUTION
Must follow the following asking when installing air curtain：
2.1 Please install the unit in a sturdy place to
avoid the shaking and ensure its security (because
it maybe cause the wall becoming flexible or
shaking and noise.
2.2 Please install the unit inside the room.

2.3 Don’t install the unit too low, no less than 2.3
meter from the ground.
2.4 When the entrance is wider than the unit, it is
recommended to install two o
r more units in
parallel. In this case, provide 20-
40mm gaps
between the units.
2.5 Don’t allow gaps between the unit and the
wall. When hanging it from the ceiling, using the
enclosed ceiling braskets.
2.6 Don’t install the unit in a place where it is
splashed by water, exposed to excessive steam,
explosive gas or corrosive gas.
3、INSTALLATION
A、Installing on the concrete wall:

3.1.1 Removed the mounting plate
Unclamping the fixed screws on the back of
main body to removed the mounting plate.
3.1.2 Fix the bolts in the proper position (Decide the
position with the mounting plate and pour cement
into the bolt holes.)
3.1.3 When the cement has freeze, fit the
mounting plate (use the washer and nut according
to the following)
3.1.4 Install the main body
Set the main body onto the upper end of the
mounting plate and clamp it as shown.
B、Installing on the wooden wall
C、Hanging from the ceiling
3.3.1 Remove the mounting plate from main body
(Same as step3.1.1)
3.3.2 Fixing ceiling brackets as Fig.
3.2.1 Fix the mounting plate in the proper
positions with tapping screw.
3.2.2 Same as the step 3 of A

3.3.3 Set the mounting plate on the ceiling
brackets and ensure safe & fixing (use the bolts
attached to the ceiling brackets as Fig. Using the
ceiling brackets to hang from the ceiling, the
position of mounting plate can be adjusted in the
limit of 100mm.
3.3.4 Do the same as stepA to install the main body.
D、For above ceiling
3.4.1 Fix the air curtain as in the procedure for
installing on the concrete wall.
3.4.2 Then pipe as
below
Fig. Instructs.
4、TECHNICAL PARAMETER
MODEL
Volt.
(V~)
220
Freq
(Hz)
60
Max input
power
(W)
Max air
speed
(m/s)
Air volume
(m3/h) Noise
(dB) Net
weight
(Kg)
H L H L H L H L
FM-4009-L/Y S6 300 270
20 16
1400 1000 57 54 13.5
FM-4010-L/Y S6 320 290 1550 1100 57 54 14
FM-4012-L/Y S6
400 370 1900 1500 58 55 16
FM-4015-L/Y S6 500 470 2300 1900 61 58 20.5
FM-4018-L/Y S6 600 570 2850 2250 63 61 24
FM-4020-L/Y S6 620 590 3255 2855 64 62 27.5

5、ELECTRIC WORK
THERMAL
CUT-OUT
THERMAL
CUT-OUT
THERMAL
CUT-OUT
DOUBLE SPEED INFRARED CONTROLLED WIRING DIACRAM
BLUE
L
N
RECEIVER
I/C
YELLOW-GREEN
BLACK
RED
BROWN
GREY WHITE
BROWN BLUE
BLACK
RECEIVER
I/O
YELLOW
C
ORANGE
(YELLOW)
RED
BLUE BLUE
BLACK
YELLOW
(YELLOW)
ORANGE
C
RED
YELLOW
C
ORANGE
(YELLOW)
6、OPERATION
6.1 Turn on the power switch
6.2 Select the best speed：High[H]、Low[L]
6.3 According to the installation place to adjust the wind direction parts to obtain the best effect.
7、CAUTIONS
a)、Use the unit at the rated voltage and frequency indicated on the nameplate.
b)、Disconnect power source before unit operation.
c)、Routing maintenance must be done every year.
d)、Never use petrol,benzene,thinner or any other such chemical for clearing the unit.
e)、Don’t allow water or anything enter the motor.
f)、When power supply comes from socket, the plug must accord with IEC335-1.When the power cord is
connected with charging line directly, all polarity switches that the contact gap is 3mm at least must be installed in
the charging line.