ThePondguy MagFlo Mini 210 User manual

MagFlo Mini
210 Pump
Product Manual
TM
Important Information........................2
Technical Specs ...............................2
Package Contents.............................3
Installing Your MagFlo Mini Pump ............ 4-5
Maintaining Your MagFlo Mini Pump.......... 5-6
Troubleshooting..............................6
Warranty Information.........................8
Table of Contents:
For Model:
THANK YOU FOR CHOOSING:
• MagFlo Mini 210
(Item #120820)

IMPORTANT INFORMATION:
Please read these instructions thoroughly before use. Failure to follow instructions may result in
equipment damage or failure, losses, injury or death.
DANGER:
To avoid possible electric shock:
• If the power cord has been damaged, DO NOT operate, the MagFlo Mini Pump should be replaced.
• Close supervision is necessary when the unit is used by or near children.
WARNING:
To reduce the risk of electric shock:
• Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit
Interrupter and never remove the ground pin from the plug.
• Provide a “drip loop” for the power cord. This is a loop in the cord below
the level of the receptacle or plug that prevents water from traveling
along the cord in the direction of the receptacle.
• ALWAYS unplug the MagFlo Mini Pump from power source when it is
not in use, and before installing, removing or servicing the MagFlo Mini
Pump components.
• If an extension cord is necessary, a cord 14 gauge up to 100 ft. must be
used. A cord may overheat if the cord is rated for less amperes or watts
than the unit rating.
• DO NOT immerse the MagFlo Mini Pump plug in water or attempt to
use a wet plug.
• The MagFlo Mini Pump is NOT suitable for use in swimming pools, swimming ponds, or other
situations where bodily contact is made with the water.
CAUTION:
To reduce the risk of equipment damage or failure:
• This pump has been evaluated for use with fresh water only.
• DO NOT place MagFlo Mini Pump near ammable or other dangerous materials or objects.
• ALWAYS unplug the unit if there is no water running through it to prevent over heating.
• ALWAYS operate the pump completely submerged for proper cooling.
• DO NOT operate during freezing conditions. Drain MagFlo Mini Pump and store in a protected
location.
IMPORTANT:
The Pond Guy is not responsible for equipment damage or failure, losses, injury or death resulting from
failure to follow safety precautions, misuse or abuse of equipment.
Power Cord
Drip Loop
TECHNICALSPECS :
MODEL VOLTAGE WATTAGE CORD GPH @ 3’ HEAD MAX HEAD INLET FITTING
MagFlo Mini 120V / 60 Hz 14 Watts 6’ 197 GPH 5’ 1” ⁄”& ½”Slip
thepondguy.com | 866-POND-HELP (766-3435)
2

Package Contents
MAGFLO MINI PUMP:
MagFlo Mini Pump
A½”Slip Adaptor
BMagFlo Mini 210 Pump
C⁄”Slip Adaptor
B
C
A
15425 Chets Way | Armada, MI 48005 3

For Best Results
• MagFlo Mini Pump should be placed on a
at surface away from sludge or
algae mats.
• Keep MagFlo Mini Pump pre-lter free of
debris.
• DO NOT operate during freezing
conditions. Drain the MagFlo Mini Pump
and store in a protected area.
INSTALLING YOUR MAGFLO MINI PUMP:
Step 1
Connect Plumbing
Connect plumbing to Mago Mini. A hose clamp (not
included) may be used but is not required when using
appropriate vinyl tubing.
Step 2
Submerge Pump
Submerge the MagFlo Mini Pump in a at area in your
pond. For ideal water circulation, place at the opposite
end of the pond from where the water will discharge.
Step 3
Connect Feature
Connect opposite end of tubing to your spitter/feature.
Step 4
Plug in Pump
Plug the power cord into a standard 120-volt GFCI
protected outlet.
thepondguy.com | 866-POND-HELP (766-3435)
4

INSTALLING YOUR MAGFLO MINI PUMP:
MAINTAINING YOUR MAGFLO MINI PUMP:
WARNING:
Before performing any maintenance, always unplug the MagFlo Mini Pump
from the power source.
CLEANINGTHEPUMP
Tools Required: • Damp Cloth or Small Brush
• Descaler such as Airmax©D-Scale™
Step 1
Unplug and Remove
Unplug the pump and move to a dry area.
Perform maintenance anytime there is a reduction in water ow or
before being stored for the winter.
Step 5
Adjust Flow
Water ow may be adjusted using the dial on the front
of the MagFlo Mini Pump.
Step 2
Remove Pre-Filter
Pull rmly to remove the pump pre-lter from the
pump motor.
15425 Chets Way | Armada, MI 48005 5

MAINTAINING YOUR MAGFLO MINI PUMP:
Step 3
Remove Impeller
Remove the impeller cover by turning counter-
clockwise and then pull to separate. Then remove the
impeller.
Step 4
Clean Impeller
Clean impeller and impeller chamber with water. A
small brush and descaler may be helpful.
Step 5
Reassemble Pump
Reassemble impeller, impeller cover and pump pre-
lter.
TROUBLESHOOTING :
Pump does not turn on:
• Check that the power cord is connected.
• Check to see if the circuit breaker is tripped.
• GFCI may be faulty.
• Check power cord for damage.
Pump turns on and then shuts o:
• Verify pump is completely submerged for proper cooling.
• Check for debris clogging the pump intake.
• If using an extension cord, verify that it is of the proper rating for the pump’s electrical
requirements.
Reduced water ow:
• Check for debris clogging the pump pre-lter.
• Perform maintenance cleaning of the pump.
• Verify that water level is not low.
• Check plumbing for clogs.
• Verify the water ow dial on the front of the pump is set correctly.
thepondguy.com | 866-POND-HELP (766-3435)
6

NOTES:
15425 Chets Way | Armada, MI 48005 7

View other great products on-line at www.thepondguy.com
PRODUCT WARRANTY:
The MagFlo Mini 210 Pump carries a 1-year warranty.
The Pond Guy will repair or replace any unit found to be
defective. This limited warranty is extended exclusively
to the original purchaser and begins from the date of
original purchase receipt. Abuse or misuse of this product
or power cord alterations void all warranty. Impellers are
wear items and are not covered under warranty. Please
call for a RMA number prior to returning product by
calling our Customer Care Department at 866-766-3435.
Failure to request an RMA number may result in delay or
dismissal of your warranty claim.
THANK YOU FOR CHOOSING:
The Pond Guy®Inc.
We Know Ponds™
15425 Chets Way
Armada, MI 48005
866-POND-HELP (766-3435)
thepondguy.com
0065_12 V2