
Water Garden Aeration Kit
(for ponds up to 4,000 gallons)
AHigh Eciency Compressor 17 Watts @ 115 Volts
BEasySet™Weighted Airline Includes 15’ of weighted airline.
CWeighted Diuser (1) PTFE Diuser (4’ Max Depth)
DCoupler (2) Squeeze Clamps, (1) Rubber Coupler
B
D
A
C
Getting to Know Your
WATER GARDEN AERATION KIT
IMPORTANT INFORMATION:
• Never connect to an extension cord. This may result in equipment failure.
• Do not allow anything to rest on the power cord.
• Do not place the unit where people may step on the power cord.
• Never override electrical or mechanical interlock devices.
• Never attempt maintenance functions that are not specied in the user manual.
• Never operate the system if unusual noises or odors are detected. Disconnect the
power cord from the outlet and call for service.
DANGER:
• Read the operating instructions carefully.
• To reduce the risk of electric shock, connect only to a properly grounded grounding-
type receptacle.
• THIS UNIT IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND FAULT
CIRCUIT INTERRUPTER.
• This unit has not been investigated for use in swimming pool areas.
• Disconnect unit from power source before handling.
• Repair and exchange of cable must be carried through by the supplier/manufacturer.
WINTER OPERATION:
DANGER:
Operating in freezing conditions on an ice-covered water garden will cause open
water areas, even in freezing conditions. Also, the ice thickness around these open
areas will be much thinner than the ice over the remainder of the pond. Injury or
fatality may result from falling through the ice. The Pond Guy® strongly recommends
that this danger of thin ice around the diuser site be clearly posted at frequent
intervals. Owner assumes all responsibility for operating Water Garden Aeration Kit
during winter months.
If you choose to turn o your system for the winter, do the following:
• Unplug the system and remove the diuser(s), airline(s) and compressor.
• Store in a dry area protected from the elements such as a garage or basement
(climate control recommended).
1
Decide on a location for the Water Garden Aeration
compressor. It’s important to elevate the compressor
a few inches above ground level, making sure the
compressor is above the pond’s water surface. If power is
not available at the pond’s edge, the compressor may be
located at the power source and extra airline can be added
(up to 100 ft) to reach your desired diuser location.
NOTE: It is recommended that the compressor be covered
and not exposed directly to the elements. This can be
accomplished by purchasing a small TrueRock™ cover (Item
#510330). If you decide to use your own cover, make sure
it will keep water from coming in direct contact with the
compressor and that there is plenty of ventilation.
2Attach the 2.25”
rubber coupler to
one end of the weighted
airline, then connect the
rubber coupler to he outlet
on the compressor. Hold in
place with the 2 squeeze
clamps provided.
3
Find a location in your water garden to place the diuser. Do not exceed the max depth
rating of 4 feet when placing your diuser. Depths in excess of this rating will greatly
reduce airow to the diuser and cause excess strain on the compressor reducing its life
expectancy. Before cutting the airline to desired length, be sure to compensate for the
depth of the pond. After cutting the airline, connect the end of the airline to the diuser
(no clamp is necessary). Place diuser in pond at desired location and turn air system on. In
case of extreme temperatures (hot or cold), it is recommended to relocate diuser from the
deepest point of your pond.
INSTALLING YOUR WATER GARDEN AERATION KIT:
thepondguy.com | 866-POND-HELP (766-3435) 15425 Chets Way | Armada, MI 48005
2 3