SAFETY
WARNING: FOR YOUR PROTECTION, ALWAYS UNPLUG THE UNIT FROM
THE POWER SOURCE BEFORE INSTALLING OR SERVICING. SHOULD
THE UNIT APPEAR TO NOT BE WORKING, DO NOT ATTEMPT TO REACH,
REMOVE, OR DISASSEMBLE BEFORE DISCONNECTING IT FROM THE
POWER SOURCE.
1. ALWAYS use a properly grounded AC outlet. Do not immerse the MagFlo™ Mini
plug in water or attempt to use a wet plug.
2. Provide a “drip loop” for the power cord. This is a loop in the cord below the level
of the receptacle or plug that prevents water from traveling along the cord in the
direction of the receptacle.
3. Be sure that a ground fault circuit interrupter (GFCI) is installed in the branch
circuit supplying the pond equipment.
4. NEVER remove the ground pin from the plug.
5. The MagFlo™ Mini is not suitable for use in swimming pools, swimming ponds,
or other situations where humans may make bodily contact with the water.
6. The power cable cannot be replaced. If the power cable becomes damaged, the
MagFlo™ Mini should be discarded.
IMPORTANT: The Pond Guy®, Inc. is not responsible for losses, injury
or death resulting from a failure to follow these safety precautions,
misuse or abuse of equipment.
TECHNICAL SPECS
MODEL VOLTAGE WATTAGE GPH @ 0’ HEAD MAX HEAD OUTLET
MagFlo™ Mini 120V / 60Hz 14 Watts 210 GPH 5’ 1/2”
INSTALLATION
Do not tamper with power cord. Connect tubing to pump outlet and secure
with hose clamp. Place pump in pond. Pump must be completely submerged and
should be placed in a level position. Connect opposite end of tubing to desired
spitter/feature and secure with hose clamp. Plug pump into a standard 120 volt
outlet with GFI. Adjust water ow via dial on the front of the MagFlo™ pump.
The MagFlo™ Mini pump should not be frozen in water.
MAINTENANCE
There are no parts that need lubrication or special maintenance. For general
maintenance or when pump ow rate becomes visually reduced, carry out the
following:
1. Unplug the pump and move to a dry area.
2. Firmly pull pre-lter cage from pump motor.
3. Remove pre-lter and wash thoroughly with water. A clogged pre-lter will
signicantly reduce the pumps ow rate.
4. Remove the impeller cover by turning counter-clockwise to release the lock.
Then pull rmly away from the pump motor.
TROUBLESHOOTING
1. Carefully remove the impeller assembly.
2. Wash parts with water.
3. Once washed, reassemble the pump.
4. Cleaning frequency will depend on the conditioners under which the pump is
used.
32
MagFlo™ Mini
Mag Drive Spitter & Feature Pump
Installation & Maintenance Instructions
WARNING
!
• To reduce the risk of electrical shock,
use only on portable self-contained
fountains no larger than 5 feet in any
dimension.
• Risk of electric shock, do not remove
cord and strain relief. Do not connect
conduit to pump.
• This pump has been evaluated for use
with water only.
• Reduce risk of electric shock during
operation of this pump requires the
provision of acceptable grounding.
• Risk of electric shock – This pump
has not been investigated for use in
swimming pool or marine areas.
• Do not connect to any voltage other
than that shown on the pump.
• Always disconnect from electrical
outlet before handling the pump.
• Operate pump completely
submerged for proper cooling.
