Thermal Edge NEMA 1 User manual

1 | P a g e
Rev. 1
METAL FILTERED FAN PACKAGE
INSTALLATION
NEMA 1

2 | P a g e
Rev. 1
Proper Personal Protecve Equipment is recommended during the
mounng installaon of this product.
MOUNTING INSTALLATION
Step 1: Using the cut-out template, locate, drill, and cut two cut-outs
for the best air circulaon.
Note: Photos are not to scale.

3 | P a g e
Rev. 1
Step 2: Ensure that the Enclosure panel is cut to the size of the
provided template. Properly dispose of excess sheet metal.
Note: Photos are not to scale.

4 | P a g e
Rev. 1
Step 3: Remove the thumb screws, grill cover, and filter.
Note: Photos are not to scale.

5 | P a g e
Rev. 1
STEP 4: Install the fan plate and opposing filter plate with screws,
washers and nuts provided; Then re-install the filters, covers and
thumb nuts. (Screw head should be on the outside)
Outside panel looking in.
Inside panel looking out.
Note: Photos are not to scale.

6 | P a g e
Rev. 1
Dismount
To dismount the Metal Filter Fan Package, ensure that the fan is
unplugged from the power source, remove the grill and filter, unscrew
the mounng screws from the Enclosure panel, and safely remove it
from the cut-out.
Filter: Unscrew the thumb screws, remove the grill and the filter. The
filter media can be cleaned by rinsing, spraying with water, or beang.
The frequency with which the filter media must be replaced depends
on the amount of dust accumulated, operang period, and specific
working condions encountered by the user.
NOTE: An unclean filter media reduces the efficiency of the filter fan
causing insufficient or total lack of venlaon.

7 | P a g e
Rev. 1
CUT OUT DIMENSIONS
100 MFFP, Size A
Note: Dimensions are not to scale.

8 | P a g e
Rev. 1
200 MFFP, Size B
Note: Dimensions are not to scale.

9 | P a g e
Rev. 1
500 MFFP, Size C
Note: Dimensions are not to scale.