Thermogroup Thermorail USS4 User manual

PLEASE ENSURE
Non-Heated Towel Rail
Installation Guide
USS4 / USS6 / USS8 / USS6B / USS6W / USR6 / USR6B / UCR7 / UCF7

2
What’s in the box?
3
Installing Thermorail
4
Technical Specifications
5
Safety & Care Information
5
Warranty Information
6
Contact Us
7
Contents

3
:
•Thermorail Single Bar Rail
•Screw Kit including:
-2 x Mounting Brackets (Supplied inside rail)
-2 x Wall Plugs
-2 x Countersunk Screws
-2 x Grub Screws (Supplied inside bar)
-1 x Allen Key
Please note these parts are not to scale
•Cross Head Screwdriver
•Pencil
•Spirit Level
•Tape Measure
•6mm Drill Bit
•Cordless drill
Grub Screw
Mounting Bracket
Allen Key
What’s in the box?
Wall Plug
Countersunk Screw

4
First decide where you want your towel rail(s) installed and measure and mark out the
bracket positions making sure they are level. Drill one 6mm hole for each of the two
wall brackets. Insert suitable rawl plugs. Now fix the two wall brackets in place using a
screwdriver and supplied screws.
Fit the Thermorail to the mounting brackets installed on the wall. You may need
assistance to hold the rail in place. Tighten the grub screws on the two wall mount
arms using the allen key provided.
Installing Thermorail

5
We recommend that the rail is installed onto a flat uniform wall, with the bottom bar at
least 600mm from the floor, with a 300mm clearance from permanent fixtures.
Recommended spacing between single bar rails is 200mm. Where possible the
Thermorail Heated Towel Rail should be screwed into studs or other suitable dry all
anchors, if fixing to hollow walls suitable anchors should be used.
Please read and understand this installation guide in full before commencing installation.
If you have any queries in regards to installation, please call 1300 368 631.
The Stainless Steel finish of your Thermorail Heated Towel Rail is hard wearing and easy
to maintain. However any harsh scrubbing, scratching or acid based cleaning products
will damage the surface of your towel rail. Cleaning with a soft cloth and a non-abrasive
cleaning agent will give the best results.
USS4
1
W450 x H40 x D100
10
USS6
1
W632 x H40 x D100
10
USS8
1
W832 x H40 x D100
10
USS6B
1
W632 x H40 x D100
7
USS6BR
1
W632 x H40 x D100
7
USS6W
1
W632x H40 x D100
7
USR6
1
W632 x H32 x D100
10
USR6B
1
W632 x H32 x D100
7
USC6
1
W640 x H40 x D100
10
UCF7
1
W700 x H40 x D100
10
UCF7
1
W700 x H40 x D100
10
Technical Specifications, Safety & Care Information

6
Thermogroup covers all its products with a satisfaction guarantee. In addition,
Thermogroup will supply a replacement product where a fault is shown to be caused
by manufacture, materials or workmanship providing the goods have been installed
correctly and according to installation instructions. This guarantee does not include
removal, freight or installation costs. Thermogroup’s products come with guarantees
that cannot be excluded under Australian Consumer Law and you are entitled to a
replacement or refund for a major failure & compensation for any other reasonable
foreseeable loss or damage. You are also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality and the failure does not amount to
a major failure.
The details on the length of the warranty on the Thermorail single bars are on page 5
of this instruction guide. To use the warranty, repair or service the customer must
provide purchase invoice/receipt and completed warranty registration form.
If the product develops a fault within the warranty period due to normal wear and tear,
Thermogroup at its discretion will recognise whether it’s a faulty product or not. If it is
impossible or not economical for the manufacturer to repair the product, the
manufacturer will replace the faulty product with a new unit of the same model, or if
there is no stock available of the same model as the product, the manufacturer will
replace the product with a new unit of a similar size. No responsibility can be taken for
altered dimensions and lining up of existing holes.
The repair service offered within the warranty period only covers the faults and
problems as developed from the manufacturer’s errors. Any damage caused by
improper use or carelessness or incorrect wiring is not covered.
Thermogroup is not responsible for any monetary loss or injuries caused by improper
use of this product.
The Thermorail Heated Towel Rail warranty against manufactures defects is a limited
liability warranty and will only apply if the product is registered online. Online
registration must be completed within 60 days of installation. Failure to complete this
form will void the warranty.
Warranty Information

7
Notes

8
Contact us
Thermogroup UK
[email protected]
www.thermogroupuk.com
0800 019 5899
Thermogroup EU
[email protected]
www.thermogroupeu.com
00353 (0)1 866 0584
Thermogroup AU
[email protected]
www.thermogroup.com.au
1300 368 631