Style selections 9005SSMV User manual

IS9006-I5
HOTEL TOWEL SHELF
ITEM #0298969
MODEL #9005SSMV

1
PACKAGE CONTENTS
Part Description Quantity
AShelf 1
BTowel Bar 1
IS9006-I5
B
A

2IS9006-I5
HARDWARE CONTENTS
Part Quantity
Description
Picture
(Shown to size)
AA
BB
Hex-Head Screw 4
Mounting Bracket 2
Wall Anchor 4
Mounting Screw 4
Before cutting, drilling or hammering into any wall surface, verify the location of electrical, plumbing and gas
lines. Cutting any of these may cause serious injury. If needed, contact your electrician, plumber or service
person.
WARNING AND CAUTIONS
DD
CC
PREPARATION
Before beginning assembly of the product, make sure all parts are present. Compare parts with package
contents list and diagram above. If any part is missing or damaged, do not attempt to assemble or install the
product. Contact customer service for replacement parts.
Estimated Assembly Time:
15 minutes
Tools Required for Assembly (included) : Hex Wrench
Tools Required for Assembly (not included) : Phillips Screwdriver and Hammer

ASSEMBLY INSTRUCTIONS
Fasten mounting brackets (BB) to shelf (A) and towel
bar (B) with hex-head screws (AA).
1. Fig. 1
BB
Hardware Used
x 4
Hex-Head Screw
AA
AA
B
A
x 2
Mounting Bracket
BB
Hold the unit at the desired position on the wall.
NOTE: Make sure the unit is level.
Mark mounting points on wall through holes in the
mounting brackets (BB). Hammer wall anchors (CC) into
wall, unless mounting screws (DD) will go directly into a
stud.
NOTE: Do not use a wall anchor if mounting screw will
be going into a stud.
Wall anchors (CC) should be oriented with the flat side
horizontal. Place unit against wall, lining up holes in wall
and holes in mounting brackets (BB). Complete mounting
by tightening mounting screws (DD) into studs or wall
anchors (CC).
2. Fig. 2
Hardware Used
x 4
Wall Anchor
CC
CC
DD
x 4
Mounting Screw
DD IS9006-I5
BB
Printed in China
Learn more about other home bath & faucets by Zenna Home on our website.