Thingiverse Light Touch User manual

02.
07.
01.
03.
06.
04.
08.
Light Touch Switch
ASSEMBLY MANUAL
Remove all the plastic support material and any
residual plastic bits. Cut off the two leads on one side ush.
Cut off the two plastic mounting lugs completely
ush.
05.
2cm
1.5cm
TWIST
1cm0 3cm2cm
Use the wire stripper.
Hold the wire behind the switch and wrap the
wire around the switch leads with a plier.
TWIST FRONT
BACK
PAGE 1 ORIGINAL DESIGN BY DAVROSS ON THINGIVERSE (#3211154)V1.1 | tiny.cc/LTswitch3

12.11.
13.
14.
Fill the indicated white rectangle with hot glue to seal in the cable. Do not overll.
If wooden skewers are used, sanding it down
slightly may help with the t. 15. Hold the ink chamber or wooden skewer while
clipping to prevent it from ying away.
Light Touch Switch
ASSEMBLY MANUAL
09. 10.
Add a small drop of hot glue. Do not add too much. Make sure the switch sitting at and level.
Hold the switch in place and bend the wire to in
between the two switch leads.
Solder the two leads indicated in the white
rectangle.
PAGE 2 ORIGINAL DESIGN BY DAVROSS ON THINGIVERSE (#3211154)V1.1 | tiny.cc/LTswitch3